I needs some help identifying the tractor model this blade will fit. I bought it for my 445 John Deere but the quick attach is too wide and will not fit. If anyone has any idea what model it might fit I would sure appreciate it. I have searched the web with the model number but couldn't find...
I posted this in the Case IH section but didn't get any replies so I'll try it here.
I was doing some tilling and picked up a rock with the King Kutter. The slip clutch engaged and I stopped and lifted the tiller and the rock came out but upon re-engaging the PTO I had some noise which I...
Hello all. It has been a good long time since I have had time to visit the forum but I know where to turn there problems arise. I was doing some tilling last night and picked up a rock with the King Kutter. The slip clutch engaged and I stopped and lifted the tiller and the rock came out but...
Well if it's not thing it's another. The poor old cylinders on my plow had set for some time and were leaking out the weep holes. I pulled one apart and the inside of the tube is pretty rough and I doubt that new seals will help. I am considering going to one dual action cylinder vs the two...
I installed a dual selector valve on my Case DX33 to operate my snow plow and 4-in-1 bucket. I split the circuit at the curl circuit and installed the valve. I have normal function of the curl funtion on the loader when the solenoid is not energized as it should be. I install hoses on the...
I stumbled upon a hardly used Land Pride PR1660 power rake with hydraulic angle. The unit doesn't even have 10 hours on it. What would one of these be worth?
I purchased a 4in1 bucket with what I was told was deere quick attach brackets. Can anyone validate by the pictures? Looks like it won't work on my DX33 but I can remedy that. If you know what loader these brackets would fit that would be great as I am going to sell the brackets and have the...
I picked up this diverter valve and I need a little advice on the best possible way to mount this on my DX33 to run the angling cylinders on my plow and operate the new 4-in-one bucket. I am wondering if I should mount the valve at the point where the curl lines attach to the hoses and then add...
My BIL installed a secondary electric pump unit on his WD as his factory hydraulics crapped out. He is trying to get power up and gravity feed down and perhaps power up and down if possible on his three point. The pump he installed has one solenoid valve and I believe to get power up and down he...
Well I just got a heck of a deal on a new 4 in 1 bucket off ebay. It looked like a lighter duty unit as it only had one cylinder in the center of the bucket to lift the clam shell. Has anyone see one of these before? For what I gave for it it really won't matter. I'll have a set of john deere...