Recent content by Chugbug

Best dealership around in sales and service, just not sure about the LX anymore......

You probably bought your LX from the same dealer as I did. I live in Ross County

Luckily no other damage......I think you might be seeing reflections, I hope anyways!!

I had a BX25 and it was a work horse, made this move to gain lifting capacity, which it has but what happened to QC??? I might be trading soon...

Purchased New, brought it home within 15 hours oil pan started leaking, dealer fixed.......within 25 hours FEL compression fitting sprung a leak, dealer fixed. Last week wife found a nut on floor in the barn (didn't think anything about it), Friday found a new 1.5" carriage bolt near the barn...

After 11 years and 1100 hours later the ol workhorse has served its purpose. The dealer will be here in the morning to haul her off after dropping off the new LX2610. We are needing greater lifting, hauling and pulling capabilities. More to come

Is anyone using a 6' blade on a BX25 (has Pat's quick connect on 3ph)?? I will only be using it for back dragging my driveway and any snow we might get. I won't be using the cutting edge but a very rare occasions, maybe cutting down the center hump in the drive way (drive way is 1/3 of a mile...

I really need to clean the engine on my BX25. Been doing a lot of gravel work (mostly 411's some call it rusher run) and the dust is caked on. I've tried blowing it if but really doesn't help much. Any sugestions? Would using an engine cleaner with water be OK (not high pressure )??? Thanks!

I'm nor so much an electrician and have looked at every thing on the Web so my questions will be easy I hope. Recently purchased a blazer LED kit. It's has 12 3 watt LEDS (1900 lumens ) and pulls 2.4 amps. I'm going to hook into the wiring harness at the back of my BX25. I will be putting a...

I'm wanting to build a dolly (wood)for my BX35 FEL and BH. Has anyone done it, ate the any suggestion, videos etc. available

Yes it will, using the FEL takes a lot longer. Our driveway is roughly 1500' so I use a rear blade to cut the drive and the FEL to remove drifts, piles etc. Since the drive is gravel I reverse the blade (cutting edge facing to the rear) and drive forward seems to work well and I don't dig the...

Looking for a rear blade for my BX25. I see King Kutter makes a 50 XB model but would like to find a 6' blade. Would the 6' King Kutter work? I saw a Bush Hog 6' (3506) blade that I really liked. Thoughts, Suggestions and help would be greatly appreciated........Oh using it mostly for snow...

I think I may have the mower set up but I noticed the self balance linkage has about 1/3" play in it. Here is a photo of the left side And here is the right side Is this normal? Thanks

Has anyone had a problem with the cutting height knob. Mine is difficult (to say the least) to put into the lock position, it moves easily from the 0 to 4 but going from the 4 to the locked up is darn near impossible, I have to raise up the deck to max then rock the lever up and down very...