Hello everyone, I rebuilt a 95 New Holland 268 engine I now have 50 hours and it's still hazing at idle with unburnt fuel. The book was very vague on timing the pump. What I did was used a dial indicator got the #1 on top dead center lined up all my gears and installed the injector pump with the...
I have a backhoe frontbucket that only has the shanks no teeth. I have all the measurements on the shanks so what is the best way to match the proper tooth for the shank?
Something is not right here. Number one you need a thermostat so that all the internal parts work at the same temperature. The oil pressure is too low that indicates rod bearing, main bearing or Cam Bearing clearances or excessive. I recently rebuilt a 268 Ford engine and they had three...
Hey guys my first time getting to use the backhoe since I bought it and done a lot of work on it. The hydraulics in the rear or making an awful noise a little slow and jerky as if it has air. I just rebuilt the boom cylinder but all the cylinders are making that noise. I can't figure out what it...
Nothing halfway here. It has new gaskets and new injectors the only problem is I couldn't find any made in the USA only China made injectors and I don't trust anything from China. I don't have a pop tester but I do have a local injector shop
I was wondering if it is possible for a injector pump to over fuel an engine?
I have a brand new 95 Ford 268 with 2 hours on it and I put the old pump back on and I'm getting just a little unburnt fuel at idle. It's a Lucas injector pump. I do need to check my injectors and see if they're...
Yes sir my battery is fully charged and the alternator is putting out. I did notice the return to dig wires have been disconnected cut Etc but I don't understand how that would impact anything. I noticed on the forward and reverse solenoids there is to Allen screws with lock nuts does anyone...
Half or full throttle it pulls great. Keep in mind I have new clutches and the torque converter has been rebuilt. There's really no issue with pulling it's just that idle when you put it in gear it starts pulling instantly. I really don't know what else to do the guy I purchased it from claimed...
Hi guys I've got a Ford 655d that is new to me. I've been doing a lot of work such as rebuilding the engine Etc but I'm having an issue when you put it in forward or reverse it jerks and starts pulling at low idle. I tested the controller and the voltage slowly goes up to 7 volts but because I...
Hi everyone I need to rebuild my boom cylinder on a 655d there seems to be two different kits one for a HED and one without an HED. I do not know what HED stands for do any of you guys?