dicktill's latest activity
-
OK, got out today and took some pictures. I literally have miles of walls, just wandered around and took a few shots. This is what... -
It takes a lot of work and some artistic talent to lay out a stone wall that stays in place. Around here the frost heaves in the winter...
-
Same here in NH - we are in glacial till and ledge and have trucked probably 200 yards of stone off of 4 acres. But did use a lot of...
-
I laid this wall at a previous property. My wife saw this pile of rocks along the road and stopped to ask the owner if he wanted to sell...
-
We went to Ireland a couple of years ago and they have miles of stone walls. Some on pretty steep hills. All those lines in the photo...
-
dicktill reacted to WinterDeere's post in the thread I hope I can prevent this from happening to other operators. with
Good Post.
What a way to go! -
dicktill reacted to mike69440's post in the thread I hope I can prevent this from happening to other operators. with Good Post.
The last few years of my dad's life he got great assistance from the VA. When visiting the VA, my heart went out for all the wounded an...
-
Doesn't that drive you crazy. Last week i was repairing my wifes rolling seat she uses for gardening. I pulled a cotter pin and washer...
-
If losing them is the only issue, it may be more serious than you thought. I am sure I have gremlins. An example similar to lynchpin...
-
Position control simply means that the three point control lever can be positioned anywhere from fully down to fully up and the three...
-
dicktill reacted to Johndeere3720's post in the thread Oil & Fuel Deere ehydro oil leak - splitting the tractor with Good Post.
Over the last year my 4410 has developed a hydraulic leak where the mid section bolts to the rear case of the transmission, just above...
-
dicktill reacted to KWentling's post in the thread M59 Help: Dealer Wants $6K to Replace the Wiring Harness with Good Post.
I urge you to set up a test light to replace the fuse. It's the way the pros find shorts. Easy to do. No more feeding it fuses. The...
-
DO NOT use a standard cutting tap! Instead use a thread-forming plug tap with an appropriate lubricant. It does not cut, but instead...
-
Old thread, but still good info: https://www.tractorbynet.com/forums/threads/3-position-valve-vs-4-position-valve.9403/
-
dicktill reacted to mike69440's post in the thread I hope I can prevent this from happening to other operators. with Good Post.
Being out of commission and being dependent on others gives me a great appreciation of how life is so precious and the freedom...