How about a grease cartridge thread?

   / How about a grease cartridge thread? #11  
IMG_8139.JPG


All I use since I got a lube shuttle gun.
No mess, fuss or drips. Admittedly I do not have to grease a lot but if I was doing a lot of equipment again then I would go back to a pail and air pump.
 
   / How about a grease cartridge thread? #12  
View attachment 3832063

All I use since I got a lube shuttle gun.
No mess, fuss or drips. Admittedly I do not have to grease a lot but if I was doing a lot of equipment again then I would go back to a pail and air pump.
I use the same! Never had a problem with "purging air" that so many report.
 
   / How about a grease cartridge thread? #13  
Red and tacky sucks. It leeches oil and runs all over the place. This Exxon grease doesn’t do that and cost about the same as red grease. I like those plastic tubes better too. My truck toolboxes leak a little bit and those tubes don’t get ruined from being a little wet. View attachment 3830251
The Lucas HD green is far thicker and doesn’t leach oil like the red. It’s all I use.
 
   / How about a grease cartridge thread? #15  
My first time attempting to fill a cartridge with grease was from a five gallon pail no cartridge and no pump. I tried to hold the bottom of the barrel in the grease and suck the grease into it by slowly pulling back on the plunger. Grease went many places and very few were inside the gun. When I finally got a box of cartridges I felt like a grease monkey gone to town.
 
   / How about a grease cartridge thread? #16  
I use the same! Never had a problem with "purging air" that so many report.

Yeah they are great. No more gloves needed just to change a cartridge.
 
   / How about a grease cartridge thread? #17  
The Lucas HD green is far thicker and doesn’t leach oil like the red. It’s all I use.
All I use, except on my excavator. On that I use Case-IH tan colored grease. I think thats what the original owner used.
 
   / How about a grease cartridge thread? #19  
Here’s the newer plastic pull cap on Lucas Green. They suck.

1753916126169.jpeg
 
   / How about a grease cartridge thread? #20  
I use mobile one synthetic grease or sometimes marine grease, it stays on even if it goes underwater. I use a hand pump grease gun I bought in 1988 from Napa for the tractors and loaders I had then. still works great today
 

Tractor & Equipment Auctions

2011 Chevrolet Malibu Sedan (A50324)
2011 Chevrolet...
(INOP) CATERPILLAR 259D SKID STEER (A50459)
(INOP) CATERPILLAR...
2014 Ford F-150 XL Ext. Cab Pickup Truck (A50323)
2014 Ford F-150 XL...
2016 Ford Escape 4x4 SUV (A50324)
2016 Ford Escape...
2013 UTILITY VS2DX 53FT DRY VAN TRAILER (A51222)
2013 UTILITY VS2DX...
UNUSED CFG Industrial XZ20R Mini Excavator (A47384)
UNUSED CFG...
 
Top