wondering if anyone would have a manual or a link to a manual for a case 1816 uniloader (skid steer) or maybe someone could give me some wisdom on whether theres a way to pull the unit (non running) is there a bypass valve for the hydraulics? or some way to disconnect the drive motors from the...
just curious with all the different brands of towable type hoes out there, harbor freight/northern tool/cadplans/dr/ etc... has anyone modified one to make them more mobile... the crawling action does work but does make a mess on a finished yard.. and transforming to towing mode for a short...
im wanting to build something to pull behind my 4wheeler... I DONT HAVE A TRACTOR!... Im not wanting a box blade more so a towable grader where i can adjust the cutting edge to take high spots off my yard.. as its going to be pulled with a quad it will be in the area of 48 to 60 wide...
working on a lil homemade backhoe and never really messed with hydraulics ... was wondering where the best place to purchase hose and fittings is? I see tsc has some hose sections not sure how there price compares with elsewhere? its a 2000lb system and im needing 3/8 and 1/2" hose. one end...
I have a pivot mechanism im trying to build which uses a 1.5 inch pin/bronze bushing/cased in a piece of 2"id dom tubing
what I was wondering how much undersize should the pin be to fit in the bronze and allow room for grease without being to sloppy...and also too press the bronze into the dom...
for you guys that are fabricating and running one of these 7*12 bandsaws im wondering what blades/tpi/ and speeds your running? I need to replace a blade and don't really know what was in mine or if it was the best suited to my needs. I use coolant. and cut mostly small structural shapes...
just wondering if you guys that mess with hydraulics all the time would know where the cheapest store would be to get my hands on this style valve... it would have 2 joystics for 4 spools and 2 individual valves for the remaining 2 spools ( 4 levers ) all built as a solid block... open center 8...
im wondering if I can take a simple 12v dc motor (say autmoboile power window motor) and wire it up to a transformer weldors output (rectified side of course) and use that motor to adjust the weldor? would it be too much voltage for the motor? im guessing open circ voltage might be 30 volts...
wondering if anyone has any good plans for a soil sifter, want to clean the stones/rocks out of the garden, and hopefully eventually find somewhere in the bush i can liberate some black soil for around the yard?
i have a spot inbetween my property and the neighbours that just holds water for days/weeks after a rain or spring thaw.. i'd like to pipe it out to the ditch at the road, total length about 200 ft from far end of water prblm to ditch where i can let it dump, i was thinking of using that black...