Search results

Does anyone have a reasonable source for a torque multiplier with a 750 ft. lb. rating? Thanks, Robert

Not wanting to admit that I am a fat a@@, but, my 250 pounds overwhelm the springs and at times they bottom out hard. Has anyone replaced the springs with heavier ones or added helper springs? If so, what did you use? Thanks, Robert.

Are the aftermarket seals for the cylinders on the loader as good as the official JD ones at triple+ the price? Mine are leaking and the price difference is about $200.00. Thanks, Robert.

Hi guys, after talking to the JD dealer my 790 is a little light for a grapple. What I would like to do is add a finger to the bucket in the center to grab branches and pin them to the bucket so that I can carry them to the burn pile. Has anyone done this and how do I handle the hydraulics...

Hi guys, While I wait for the dealer to open, has any one built/bought a grapple for their bucket? We had a forest fire here (almost lost the house, thank God for volunteer firemen) and I have tons ( up to 1000) of trees to remove and a grapple would make quick work of the branches and trimmings...

Hi guys, what is the procedure for removing and replacing the front drive shaft on a 790? I can see that the bolt on the front spline has to be removed but what is under the rubber boot with the two hose clamps? I assume that there is another spline but will I lose fluid and are there any...

Hi guys. I have a new to me JD 790 with a few problems that I think are probably minor but would like to know for sure. 1.) The tie rod has an "S" curve in it. I will make the attempt to straighten it since I have a press. 2.) The other problem that I have discovered is that the front drive...

Hi guys. I have a new to me JD 790 with a few problems that I think are probably minor but would like to know for sure. 1.) The tie rod has an "S" curve in it. I will make the attempt to straighten it since I have a press. The other problem that I have discovered is that the front drive shaft is...