briggs

I'm hoping I can get some help identifying the size of these threads on this engine. I picked up a replacement engine for my garden tractor and all is good except for the threads in the exhaust ports. This is a Briggs opposed twin flathead, model 422447. The previous owner tried to thread 3/4"...

Hi All, I have the briggs engine listed and removed the sump to replace the gasket when I discovered that the pin that holds the idler gear had snapped in two. I went to several parts websites and can't find this pin in any of the descriptions. Each end has a groove to insert an E ring...

Got a 28HP commercial briggs in a Ferris zero turn. It was leaking oil from the sump gasket. Got that all replaced. On initial startup, the engine revved to the moon. Shut it down quick, and proceeded to attempt to adjust the governer I loosened the governor arm on the shaft so I could spin the...

I have a 445677 0476 E1 Briggs Eng on a Husqvarna lawn tractor. Ran fine shut it down and the next day when I tried to start it it backfires through the carburetor. I checked the coils for spark, checked flywheel key all ok. I took carburetor apart and cleaned it. Still backfires. My next...

Looking to get some advice installing new motor on my 2002 LT150. Family member purchased a brand new 19hp EX1900 but did not receive any installation instructions. Previous motor had 2 wire plug, red and white, while new engine has grey black red and orange. I've spent a couple hours tracing...

I am looking for a B and S Fuel Tank, OEM part #297257. I am even open to good used. This is an old 70's engine, but runs great. Gas Tank rusted through.

The Briggs engine on my JD Z225 started acting up around 200 hours. Adjusted the valves, replaced the carb, fuel filter, fuel pump, ignition coil, head gasket... It would run okay for a while and then start acting up again. Finally had enough even though the mower and engine only has...