farmall

I have a typical Super C tractor that just goes on long tractor drives with the guys. The amp gauge would normally show maybe 5-10 amp on a ride. It has a crappy battery and had a new voltage regulator on it when I bought it. I had a shop check the generator last year and they said it was OK...

I have a farmall 31 that had sat for awhile, after starting it would barely move and the peddle would shutter really bad and after 30 seconds it took off like normal. it then seemed to loose speed and would only move under low rms, now after sitting for a couple hours in the cold it wont move...

My super a has 11.2x12.4x24 rear tires and needs a new rim on left side. I found a super a I can cannibalize but it has 8" rims. My 11.2 tire says on it that it goes on 10" rims. Can I put the 8" rim on and still use my 11.2 tire? Would rather spend 75 on an older rim rather than 300 on a new...

Hi, The accelerator works fine except it will not stay in place. No tension is on it, so if I set it at about 50% it will drop to 0% (still runs) immediately. If I hold the accellerator in place by hand it drives/works fine. Any ideas? Its ~ 10 hrs old and the first time I opened the motor...

Can someone give me an education on the 1950's Farmalls with a Torque Amplifier? I've always avoided them just because everyone said to so I know very little. But---I've found a 1950's Farmall that I'm thinking of buying as a parade tractor but it has a TA. I know models with a TA sell for...

Hi all, not sure if this is in the right place. If not please relocate... I have a Farmall BN that runs and drives great except... When I let out the clutch the left side seems like it jumps around... Almost as if there's a u-joint with bad bearings in there, but I took off the couple caps I...

I am putting an accumulator on my Farmall 110c for the 3 point hitch. I believe the port is right under the cab but no one at my dealership can tell me for sure. I have also heard it may mess with my draft control but will worry about that more when I figure out where to hook it in. I believe...

Farmall 706 won't start! Was running fine a month ago , it has non- oxy gas in it but just turns over until battery dead. I know it needs to run more frequently but just slipped my mind.

Always wanted one of those old Shibaura built Boomers or Farmall's and almost bought one today. Found a 2008 cab model with loader and rear snowblower, hydro, rear remotes and only 945 hours. Dealer said it was never used commercial and was a homeowners. But all the back end around the 3 point...

Anyone here with experience on the 75A or 75C? Curious about the good and bad and first hand experience. Also if you have one what tasks are you using it for and are you happy with it? I currently have a JD 3720 and looking for something bigger to run my 4X4 baler and other hay equipment.

Any way of telling what year my inherited Farmall Super A is. The label under seat is unreadable.

Any opinions on a Famall 50 with cab and hydrstat transmission? A 2010 is up for sale near me and Was going to take a look at it. Any thoughts? Good? Bad? Thanks.

How do I tell the year of my Farmall Super A? Thanks

I inherited a Farmall super A, it's been sitting a few years, I know battery is dead. Connected a good battery by booster cables, barely turns over twice and stops. Took starter off connected directly to battery, gear pops out and spins. Stuck screwdriver in starter hole and made sure flywheel...

Moved back to the family farm in Indiana about a year ago, and finally getting settled in on the farm. Mom just rents out all the ground and we have no equipment other than Grandpas M that he started farming with. It was our auger tractor when I was growing up. Had a manual trip loader on it...

looking fo a belly mower for my 35 need to know which model mowers will work on a farmall 35 2011 model. Thank you in advance

Hello! I am new to the site and new to older tractors (or any tractor for that matter) and I'm happy there are forums for older tractors here. Q: Does anyone have an idea as to why my PTO whines when disengaged? With PTO engaged it runs fine with no noise - but I fear just running it all the...

Hi Everyone, Have a 2012 65A that we keep around the farm for light duty work. It is lower hours (under 1200) and we have started having an issue with it today. After about 45 mins to an hour of run time (this time it was on a rotary rake), it will begin to churn smoke and lose power. Once you...