international harvester cub

I have a 1964 IH Cub lowboy with a belly mower. I have used it this year with no problems. Pulled it out of the garage for it to warm up and start and ran fine and then died and won’t start since. Gas drips out of the weep hole. Cranks over fine. Any ideas?

This front power takeoff operates the mower deck. No matter what I do with the lever or loosen the clutch lever, I can't get the clutch to disengage fron the drive shaft. The lever wear button was in fragments and i don't know where the pressure spring thrust button is located. do I have to...

Me n my buddy made the trip to Florida to see what we can do with his dads old tractors. Gonna work on the IH first, because it was running not long ago. Going to grab a battery now, supposed to be a 6 volt positive ground system. The Massey has been sitting for a few years with the head...

I recently bought an IH Lo-Boy and had the alternator-generator rebuilt. The tractor now starts fine [ it doesn't use a starter], but it isn't charging. I followed the wiring diagram F to F and Gen to A on the alt/gen and battery to battery and I polarized the regulator but still slightly...

Had a radiator leak in my Cub Lo-Boy. Couldn't remove the drain plug, so I took the radiator out and caught the antifreeze in a tub. Drained the bolster and filled the plug hole with PB Blaster. I only have a small propane torch, but it was enough heat to allow me to break the plug free. I...

I picked up this garden tractor at a farm equipment consignment auction for less than $150. It has the grass /leaf catcher box on the rear..feed s from the side discharge thru a large plastic tube to the rear. I can't find any other model ID on it other than the CC logo and the "Hydra" on the...

I am thinking about buying a 1948 ih cub tractor with a 4 foot sickle bar mower. What things do I check on the tractor/mower to avoid buying a lemon or a bunch of problems? Thanks for any help or suggestions.

I bought the tractor last year, actually went for the rear Cadet tiller, hoping it would work on a friend's Cub 129, but the seller had the 124 ( for which the tiller intended) dismantled and had given up on repairing the engine so I picked up both. Over the winter I reworked the engine because...

So, I'm a cub fan and the old man is a deere fan. Earlier this winter he was telling me my cub would never be half of what his 317 is. Me being me, I decided that was a challenged and this winter I pulled this what was stock 800 with a blown engine into the garage and this spring I pulled out...

Hi, Several years ago I purchased a IH power unit for the motor which I put in my Cub. I would like to get rid of the reduction, radiator, gas tank, and stand that is remaining. The serial number is 64HTC252 9, the reduction is around 2.3 to 1. I was wondering if anyone out there has an idea...

I've been searching for a GT to use at the mower for my camp. I ran across a 50's vintage IH Cub with belly mower for what I think is decent money - I'm thinking of maybe getting that to mow the grass. Seems the coolness factor and fun of mowing with a vintage Cub would far outstrip any GT I...

I have just purchased a 1969 IH Cub Lo-Boy . There is smoke coming out of the oil breather. How can I cure this? Thanks

Hi There, My Name is John I have just purchased a 1968 IH Cub Lo-Boy . There is smoke coming out of the oil breather. How can I cure this? Thanks

I have been looking at a old IH made cub for a couple of month now and I talk to the guy who own it and he said it. Had a knock in the motor would it be worth restoring it I think the motor is a kohler and its a cast iron block thanks

Just joined-glad to find the site-my Cub is a barn find, many parts missing so half the battle is finding out just what's gone! Found a good hitch and a Brinly plow, also an A-frame cultivator-probably also Brinly-but missing all the wedges and shoes-looking for a disc set, either single or...

Hello, I own a 100-acre property of which I regularly mow roughly 10-12 acres on a bi-weekly basis. Tractor-wise, I currently have a 1970 Ford 3000 gas (2360 hrs) for which I have many 6' and 7' implements including a 7' Woods finish mower; a 1966 IH Cub Lo-Boy (Yellow and white, offset) with...

My brothers father-in-law passed away last fall. The family is going to sell the IH Cub Lo-Boy that was in the barn and giving me first shot. No one knows the year or much about it. They think late 40s or 50s. They went away this weekend and said to stop and look it over. Runs good and has mower...

I looked at and drove a 16hp Cub loboy, 1953, today, which is for sale. Both reverse and 1st gear make noticeable gear noise. 2nd and 3rd gears don't do this at all. Is the gear growling in low gears normal for these units? Owner says he's had it 35 years and "it's always been like that"...

Hydrostatic drive, 17HP Kohler engine, 42" mower deck. I also have an IH snowblower attachment, which I bought off the internet and never got around to using. It's in good shape, a few scratches and dents, but no major rust. It runs, although it's not too happy about the new gas formulations...

Hey y'all. I didn't know exactly what section to put this in, but this one seemed like the closest. I'm working on a 154 Cub LoBoy. Long story short, I need to remove the R-1 shift fork from the transmission. I have the top cover off, the clutch removed, and the bracket for the clutch brake...

I have a 982 and am not sure what to do with it. It has a 60" belly mower, everything works on it (except it needs a new belt). It is in good shape, but you can tell it has the original paint (it is dull and worn in spots). I don't need it anymore. Question-Should I sell it as is or restore...

I have been shopping for a lawn tractor, and I have it narrowed down to Kubota G6200 for $1400 (asking) and a IH Cub Cadet 982 for $1000. The Kubota is in decent shape - the diesel runs well, the 40" (yes, 40") deck is heavy and solid. However, the fiberglass body has one long crack above the...

I need to replace original Kohler KT17 twin in my CC 782. During last snowstorm, I was blowing more oil & smoke than I was blowing away snow, as well as had no power. I had blown head gasket some years back when engine overheaded due to some undetected field mice nesting in the cooling fins.The...

I have a Cub Cadet 1250 that will not spark. I bought new condenser, new points, new coil. And I have power all the way to the points, and the gap is set to .015, which is what I was told to set them at. But still no spark. My dad, grandfather, and myself have no clue as to what could be...

I've been thinking about getting an old tractor to restore just for fun. I found a 1950's IH Cub Lo-Boy locally for $600. I haven't gone to look at it yet, but the guy said it ran great when he parked it 3 years ago. The only problem he said was the PTO shaft splines where worn. He also said...

I have a 1966 Lo-Boy and I just noticed this forum. Do you guys include the Lo-Boy in your discussions on this forum? My tractor is not the 185 or 184. It is just a "Lo-Boy". KEG

Well I bought a nifty old garden tractor and need some advice. It's a IH cub cadet 782 in pretty good shape (see picture). It was made in 1980-81 and is hydrostatic, with hydraulic deck lift, electric pto, and shaft drive. Problem is, as you can also see in the picture, the engine came in a...

I am looking to replace the original tired Kohler KT17 twin in my CC682, it is losing compression. The only drop in replacement for this tractor from Kohler is the KT17 Series II, which is over $2000. (Shoot, I can get an engine for my CAR cheaper than that LOL) The only improvement I see SII...

I'am thinking of purchasing a 106 it looks to be in great shape for old machine.Just wondering if any one out there has rebuilt one and the pros and cons.I would like to find a 127 with a hydro. since I would use it to blow snow and I know you get a better cut with the hydr o. but I can't seem...

I have a snow plow blade (including undercarriage) which was removed from a 1980 Model 1200 International Harvester Cub Cadet machine, and I would like to know all of the models which this plow will fit. A photo can be seen at http://mysite.verizon.net/edmcc/blade1.jpg . From the limited...

I am looking at getting an IH cub cadet 128 tractor with a mower deck. I think it is about a '71 - '74. Is it worth $300. It works well and has just been gone over mechanically. Starts right up all the time. Just seeing what everyone else thought. Thanks Mike

genny question on 66\' IH CUB Howdy I've got a 1966 IH cub ( 12v ) and a cow got in the barn last night and ran her horns all over it. Pulled ignition and plug wires, and pulled the wires from the genny as well. Ignition and plug wires were easy to figure out. Genny is a bit harder. Can...

I had all my important info written down for this tractor neatly tucked into its manual... and have now lost it. If anyone has the oil filter number I would greatly appreciate it. I plan on servicing it tomorrow if possible and would love to have the stuff on hand.. instead of hoping I can...