john deere 1025r

After looking at SCUT tractors that better fit my needs than my current Mahindra, it came down to the JD 1025R with backhoe and the BX23S which is standard with the backhoe. I have had a local JD dealer price me a 1025R with backhoe and 60" 7-Iron MMM. I also had a local Kubota dealer price...

Make property management 10X easier with the Ultimate Rack®. Replace Your UTV / Pickup Truck - 600 lbs. load capacity + tow up to a 2,000 lb. trailer (With load on the wheels.) Doubles As A Ballast Box - Built with 300 lbs. of 11 Gauge Steel. Increase ballast up to 1152 lbs. with suitcase...

A 2016 John Deere 1025R with Powerflow Material Collection System! $15,000 less than new! At 247 hours, this 1025R is powered by the 23.8hp Yanmar 3TNV80 diesel, 3-cylinder, liquid-cooled engine with a 2-range hydrostatic transmission. Equipped with the 120R loader and JDQA bucket, and the 60″...

What is the fuel consumption rate for John Deere 1025R? Is there any place in manual or websites where the fuel consumption is listed?

I would like to sell my 2014 1025r and brush hog because I don't use it. I use my JD 595X instead becasue it is a little smaller. 125hrs, 60" deck, front grill, Frontier 2048 chopper, seat cover...all good. What is a fair price? My dealer will give me $12,000 on trade but I was told I would be...

How many rear SCV's are available on a John Deere 1025R as an option at the time of purchase?

Last summer I picked up a new John Deere 2021 1025R with a 54D MMM. Since I have a dedicated mower, I mostly use the 1025R for the bucket and the Artillian grapple. However, I did use the 54D mower deck last fall and clocked an hour or so of use before the season ended. For the winter, I...

Ordered new tractor ordered 6’ MMM 4’ aerator sprayer loader and backhoe for tractor

Hey JD1025 operators, If I have the tiller (or whatever) on the three point, and the mid mower on, can I raise and lower the mid mower while holding the three point attachment up the whole time? I thought I could close the rockshaft knob to isolate the three point, but that stops both the...

Looking for posts on the JD Subcompact 1025R and didn't see any. No problems from me but some others may have. Mine is running fine with only 30 hours on it so far.

I am in need of a material bagger for my 1025r. I found a used JD bagger that has 3PH mounting as well as a couple bars for a different mounting setup. For this bagger to work for me I've got to keep the 3PH up but drop my mower deck to mow. Below are some pictures of the bagger. Any ideas on...

Tractor: John Deere 1025R Loader: 120R with 53 bucket I know ballast has been discussed in the past and I have been looking at several different forums and discussions about tractor ballast. I found a ballast calculator that someone created for the 1025R, and what I am confused about is that...

Right tractor? Price check? Hilly sloped property...JD1025r, Kubota 2680, LS, GT ZTR? I have about 6 acres of varried terrain almost all of which is a slope. From 2-5 degrees to 25-35 degrees. I currently pay a guy to mow the 3 around the house and another guy to brushhog the 3 acre field out...

Members, I have a question looking for thought grenades on an offer that I have from a JD dealer for a 2017 1025R with zero hours. Package is listed below: 2017 JOHN DEERE 1025R SubCompact Utility Tractor (18 PTO hp) $12,540.00 2019 JOHN DEERE 60D 7-Iron Mid Mount Side Discharge Mower $...

I am looking for feedback how the John Deere 1025R lift and curl function at the same time if this is possible and how easy it is to achieve? I know the Kubota BX is easier, but would like to know how the John Deere 1025R how easy it is? Is there a difference with the lift and curl from...

I have a 1025R coding 523591.14 Says reverse and forward pedal wiring swapped. Was driving thru yard, when this code popped up. How did my wiring get swapped???? Lol! Now PTO comes on but when going forward or reverse it shuts down the PTO. Anyone else, experience this problem? Thanks very much...

I see from several forums that there are a few of us (like me) having problems with tree limbs breaking our ROPS hazard lights and these **** things aren't cheap to replace. Though I try to be careful not to hit them it seems the limbs jump out and grab them. So after a little brain storming I...

Hello everyone my name is Brandon and im new here. Me and my father n law are looking to buy a new tractor. We have been looking at the the sub compact JD 1025r and Kubota bx23s. Both look the be good machines so we are having a hard time picking one. Price between the 2 are only about $2000...

Hello all I am a new member from Nova Scotia who has owned a variety of heavy forestry equipment and industrial equipment over the years. We have built a new house on 70 acres with lots of blown down trees which we will cleanup as the years go by. The house will have about 3/4 acre of yard...

Good evening, We just bought an acreage with 5 acres of overgrown honeysuckle and neglect. We are starting to thin it out (not clear cut) to increase the size of our yard into more of a park like setting. I have a TON of chipping and shredding to do. We are in Ohio and heat the house...

Hello everyone, long time lurker, first time poster. For the past month I've been scouring this forum and a few others trying to figure out what brand of tractor and what size of tractor to purchase. My first thought was a John Deere 1 Series but you guys convinced me I should buy bigger, that...

:thumbsup: I brought my JD 1025R with Backhoe, Loader, and MMM home. I have played with it for a few hours, but it started raining a few hours after I got home. It has been raining for 2 days now:muttering:. Here are a few pictures and a video my wife took without me knowing. I am starting to...

I own close to 3 acres, much of which is woods that I need to work on clearing and improving. Also about a 300 foot driveway to plow in the winter. Not worried about mowing as I have a JD X500 for that. Looking for practical advice on selecting one over the other. Specs are in the ballpark...

Hi everyone, I'm new to the forum and am looking for some feedback for my scut or compact purchase. I have 2 acres to mow and have a 300' x 30' driveway to remove snow on, we get a lot of wet stuff and ice during our winters here in eastern Ontario. Using the FEL to work on some retaining...

I'm in the market for a NEW John Deere 1025R with H120 Loader and 54D Mid-Mount Mower. What have other paid for this 1025R tractor and attachments?

I been reading where a lot of members say that using a front mounted brush cutter causes a lot of flat tires. Is that the case for rear mounted brush cutters also? So would it not be worth using a front mounted brush cutter. I like the idea of being able to see better and not getting a sore neck...

I have a JD 1025r FELB and 15 acres and I have been cutting down trees and pullin out stumps and making a road around my property so I can someday put up a fence around the property. I would like to adapt a Brush Hog to the FEL to make brush removal easier to view. Even though I realize a lot of...

Just got a new JD1025R to replace my JD X595 which was a fantastic tractor. As I live on a hill a certain amount of mowing is on steep country and it requires travelling up and down only. Shocked to discover that while I mow to a vertical drop that if I forget to pull out overide button the...

I've been looking at the 1025R and the BX2370 I could live with either. I've gotten quotes on both with a 60" deck and loader, I added the quick connect to the BX FEL. The out the door price for the 1025R is $16400 and the BX2370 is $15000 out the door. My question is, can I get a better deal...

Good morning, this is my first posting, and I am brand new to TBN. I have an order in for a JD 1025R loader / Backhoe / 60" mid mount mower deck, and turf tires. I have made up mind, and this is what I need for projects around my 1.5 acre. I see there are complaints about seat springs, mower...

I like the JD1025R, with its easy attached mower deck, but no thumb available on the back hoe. The Kubota BX25D has an adjustable thumb for its back hoe, but a more difficult attach job for the mower deck. Am I overestimating the difficulty of attaching and removing the mower deck on the...

Does anyone running a JD1025R have trouble breaking shear pins on a 4ft. brush hog? If so do you have a solution?

Has anyone and any problems with their 1025r is so what where they and and comment if u have one tell me what you think

Hello everybody, I am in the process of purchasing a new john deere. I would like a 1025r because it fits my shed and is very agile. It wil be used for cleaning the horses stables, transporting hay bales and maybey some minor mowing. I've got some quotes from dutch dealers starting from 19.000...

Hello, This is my first post to the forum and I am looking for some advice. I recently bought 6 acres of property and it is all grass. There are some considerable hills to mow. I had the JD dealer come out to look at the property. He mentioned the hills were too much for a zero turn and...

Sold My Old Wheel Horse. Looking At Bx2370 Or Jd1025r.Leaning Toward Kubota. $2000 Difference InFavor OF Kubota. Dont Like The PlastiC OfJd. Any Thoughts

In the market for one of these two machines....it will be one of these two. I would like a grapple on it and really like the looks of the Land Pride SGC05. Moving brush, picking up RR ties will be a big ongoing job for this machine....whatever it ends up being. In looking over the Land Pride...

Getting ready to purchase a new John Deere 1025R with FEL and 60 inch mower deck. Total price is 16,500. This looks reasonable. Adding a canopy cover for $325 also. Need one here in South Texas. Will be cutting about 4 acres, gardening etc so I believe this is about the correct size. I...

Hopefully the format of this post doesn't get garbled.... Just got this quote back. Goal is to have a subcompact that mows superb, snow removal for 400' driveway and fairly light loader work. I want the implements to be easy-on/off and fully adjustable hydraulically. Hoping the guru's out there...

Originally started to look at the BX25D with backhoe and loader, and a JD 1025R with backhoe and loader... then thought about going bigger to the JD 2 series, the 2520R (but they are phasing those out) replacing it with 2025R. So the dilemma is try to find a 2520 or wait a month and get the...