kubota m5140

Bought a used m5140 serial number 50561. Only 3rd time I’ve used it. Started fine, then running rough at idle. Eventually died. Cleaned the water bowl and could not get gravity flow from tank, so I filled it with diesel. Pulled and filled up spin on fuel filter. Got tractor to start again but...

My Kubota M5140HD I don稚 know what caused this as it was this way when I bought it from the original owner, it has low hrs. There a gap between the instrumnent panel clear cover and the rest of the main Dash housing. The gap is about 1/4 inch where moisture and dirt can get into to area. It...

my Nephew had his tractor stolen Saturday Night. Tractor was located in the Murphy NC area. A reward is being offered for information. sine we are located close to the Tenn and Ga state lines, I suspect the tractor could already be out of state. I appreciate if everyone can keep a look out and...

Does anybody know of any dealers that still have a new M5140 or similar Kubota with fel and 4wd?

Got a brand new M5140 a couple months ago. Drove about 500 miles to avoid getting the latest model with tier IV emissions. Its got the Hydraulic shuttle, 4x4, loader, and the bigger 16.9 R1 tires in the back. Also bought a new Woods RD990X mower to cut my 10 acre yard (had to sell a scag 72"...

New member here. I recently bought a new tractor (after running antique ones my whole life). It's a Kubota M5140HD 4x4 with FEL. Anyone know where I can find or buy a shop service manual and/or a parts manual for the M5140? A google search didn't return any useful results. One thing I'm...

Hi, Could someone please give me a rough estimate of a enclosed cab Kubota 2012 m5140 with low hours, loader, back blade? I have an opportunity to buy it before it gets advertized. Thanks

Hey guys, Got a brand new M5140 and when I attached my 296 BH cutter, I realized the 3-point hitch does't raise the cutter as high as my previous Ford 4610 did. It is set as it came from the factory. The lifting rods are screwed down as far as they can be and they are attached to the lower...

My wife and I are young farm starters. We bought 150 overgrown acres in the mountains about a year and a half ago. We've been saving up to get our tractor since that time and finally this last week got a Kubota M5140 with front end loader and a 6' rotary cutter :). I've lurked on the website...

My dealer is getting a M5140 for me hopefully in the next week and I would like to find someone with an owners manual that can give me the available tire spacing so I can make a decision for the setup of the track width. Also what does the manual say as to rear blade and scraper blade lengths...

I posted a previous thread about the great deal I got on this tractor and that I would post a few pics. Thanks again for all the great answers to my posts.

Just picked up a used Kubota M510 from a private party. Paid off his lien through Kubota Credit Corp. 2012 Foldable ROPS, 4WD, DT, FEL W/72' bucket, forks (Older Bobcat forks-QA), third function valve, extra front and rear remotes, 2012 woods BH90-X with hydraulic thumb, and with 49.8 hours...

I recently posted a pricing question on a used 2012 m5140 with FEL and woods bh90x for $35,000. I have 85 acres mostly wooded. I snow blow around half a mile of drive way and rough mow about 4 acres. I have never owned a backhoe, but have used one and it will be very handy for all types of work...

Hello, I am in the market for a new tractor. I was looking in the 40-45 hp range and found a 2012 Kubota M5140 with 72" FEL and Woods BH90x backhoe with hydraulic thumb, loaded tires (Ag), 50 hours, still under warranty, extra front remote and forks for $34,500. Seems like a great price. Anyone...

Hey all, I've been lurking for a while trying to learn something. I thank all of you for your previous posts as they have helped me make a decision - sort of. I am pretty well sold on the Kubota M series tractor. I have a great local dealer and every time I look at the Ms wanting to not...

What do you guys think about the kubota m5140? I really think it is big enough to do what I need. I have around twenty acres that I cut and plenty of fel work to do. What size cutter can it pull?

My 3ph is weak it's a new tractor with 100 hrs. Dealer came out and set the relief at 2800 psi and it still will only pick 2400 lbs plus my skidding winch at 575lbs = 2975. It's is rated for 3307lbs. I would think that would be able to pick even more that that with the pressure turned up? I am...

The only difference I see in these two tractors is the engine and about $1500. The 5140 has the V2403 (149 CI) and the 6040 has the V3307 (203 CI). At the dealer's lot, the V2403 engine seems to rattle with the familiar "diesel ping" and the V3307 does not. Also, I noticed that at 35...

Looking for any advice and comparison between the MX5100HST and the M5140 hydro-shuttle in terms of performance and fit for doing grapple work clearing brush and trees. Will be using tractor to clear, move and stack brush and also to move and pick up downed trees to waist height for easy...

Tying to work through all the pros and cons for each of these machines and which one would make the most sense for my needs. Primary use will be cutting 20 acres of fairly hilly pasture land, not too steep though and secondary usage would include general maintenance of gravel roadway, fence...

What is the difference between a Kubota M5040 and M5140? From what I have looked up I can find little difference but Kubota would not have changed the model number for an identical tractor.

While the older M5040 used to be offered in ROPS and CAB models here, the new M5140 that replaced it is available in a CAB model in the USA but only ROPS in Canada. I'm considering a M6040 as a result but I thought the M5140/M5040 would have been just fine since what I was looking for over the...

Hi everyone. Need some help from u guys. Today I have an BX24 which Im very happy with. But sometimes it too small. For example I need to get a "trailer" with a hydralic crane to do some work in the woods, trees catch by storms etc. I find that the BX24 dont have the ground clearance aswell to...

which is better ,thinking about trading in my m4900 for the newer style m5140 . am I going backwoods from a 5 cylinder to a 4 cylinder ,is the m4900 better built?I like to get a hydraulic shuttle and a 3rd remote but thats not worth it if the new 5140 is less machine.

Hey guys, I'm in the market for a new tractor and I'm looking at the M as a strong contender. I've been looking at a few Deere models too but I figured I'd do better to ask about the M5140 here. I sat on a couple today and I gotta say I'm very impressed. I have a few questions though. Does the...

I have a good friend looking to replace an older ~35 horse Kub with a newer ~50 horse model. He is looking at the following 4WD models: Mx5100 M5640SU M5140 Use includes general horse farm maintenance duties, mostly mowing with a brush hog and light loader work. I researched the tech specs...

In 25 words or less: what is the difference in these two machines? Simple answers like "$5K" is not what I am looking for. I want to know how important the "deluxe" features are. Any insight will be appreciated.

Has anyone purchased one of these if so any compliments or complaints?

In my search for an M5040, I've had a few dealers tell me that Kubota is getting rid of the M5040 (one even said he couldn't order it anymore), and replacing it with the M5140. Does anyone know anything about this?