new holland tc45d

I have an older tractor. Replaced the battery, now won't crank. Fuses are all good, panel lights up, at a loss.

2002 NH TC45D. ~1,900 hrs. I was operating the tractor when a noise started coming from the engine. Seemed almost like a rattling inside. Shut the tractor down and now it won't start nor turn over. -Turn the key to start and there is a single clink/clunk sound and that is it. No multiple...

Looking at a New Holland TC45D tractor and was wondering what your opinions of that model are? Any problems? Anything to look for? It has a hydrostatic drive, 4 wd, 16LA loader, two remotes in the rear, 2400 ish hours. Looks to be in nice condition, I have not started and driven it yet...

Does anybody have any tips in fixing the Fuel gauge and Engine Temp gauge as both are not working on the panel for my 2002 NH TC45D. Speedometer is working. Where to start looking to get this fixed? Thanks

Good afternoon all. I have a TC45D NEW HOLLAND and it has set for a bit. It would shift into four-wheel-drive when I parked it but now the shifter will not budge and I feel that if I force it, it will bend the shifter. I am also having trouble with shifting the PTO. My dealer tells me to...

Started just fine; have used in recent days; was driving to project in field; just stopped running ; full of fuel; panel lights up; Will not turn over; Good seat switch; Full of oil; Suggestions please

I just upgraded to a NHTC45D and it needs a bit of work as we have hydraulic leaking from the center of the tractor, antifreeze leaking, front wheel seals gone maybe as it's leaking as well. I have a number of electrical issues that need to be addressed as well. First all this forum has been...

I have a 2003 New Holland TC45D that I'm having issues with. I have a good supply of fuel when I loosen the bolt on top of the fuel pump to bleed the lines, but I cannot get any fuel to the injectors. I have tried loosening them and cranking when they are loose, but no fuel arrives. Any...

I have a NH TC45D with a hydrostatic trans. Recently the starter has been staying engaged after cranking the engine and occasionally it will re-engage after the engine is already running. Usually, if it stays engaged or re-engages, it will disengage when you put the trans in gear. If you then...

Hi all, I am going to check out a 2003 New Holland TC45D today. It comes with a matching loader and sub frame backhoe. The machine has a cab of some sort on it and is listed as having heat, and has approximately 1500 hours. The machine has seen duty on a horse farm, and is listed at 19,900...

Hello everyone, im having some fuel issues on my 2002 New Holland tc45d the tractor has about 3,360 hours on it. the fuel filter is in a clear plastic housing so you can see if the fuel filter is full or not well when your running it there is only a little bit of fuel at the bottom so if you rev...

I am having a heck of a time finding an engine for a New Holland TC45D. It has a Shibaura N844L engine, which I believe is also in some Case Tractors. The block cracked and can not be fixed. The dealer wants $9,200 for a new engine. I found a new N844LT (turbo) on ebay for $6500...but it was...

Ive been having some issues with the instrument cluster on this tractor. Recently the Oil Warning light started coming on intermittently , however there have been no real issues with oil level. Checked all fuses, relays, and wiring associated with cluster but found nothing. then the hour gauge...

Would like to know the value of these two (2) tractors. The TN75 is a 2004 (low hours) with a "custom-made" steel cage built onto the tractor. It is equipped with a 5' Brown Tree Cutter. I used the tractor to clear out over grown property and to cut paths for surveyors, etc. The TC45D is a...

I am carrying this over from the New Holland forum. I have a NH TC45d that I purchased in a few pieces but that is another post. I have been running it now for a few years and need to add a rear remote. I have a Bradco backhoe that I use on it and get my power from the Power Beyond on my...

Can you tell me where I should begin to look for a problem with my 4WD not working on my New Holland TC45D Tractor. It is a 2001. The lever will not move forward to go from 2WD to 4WD. I can't afford a mechanic and have to figure it out myself somehow. Thank you

Hello, Im new to tractors, not sure what is going on. I was pushing around dirt with the tractor for about 2 hours. The needle on the temp gauge was half way between the green that is just before the red portion. It will go down under no load. However, at the 2hr mark the tractor started...

All, I'm somewhat new to the forum and Tractors. I was plowing and a large root popped up and snagged the rubber t-coupling for the main hydraulic line under the right side of the tractor. It was pulled off enough where there was a slow leak and no power to any of the hydraulics to the...

Recently my starter has started to sound like when you hit the starter on a running vehicle. I assume the gear at the end of the starter has an issue and I need to replace the starter. Thoughts? And, where is the best place to get a starter at a good price? Thanks

A local tractor store has a 2005 4x4 New Holland TC45D tractor (4K hours) that includes a front-end loader that has a quick-release for bucket swap out. The front tires are new, but the rear tires need replacing. The tractor has a clean, intact exterior and no leaks. Everything seems to work...

I have both of these tractors. One (jacobsen) is a mower and the other is a compact tractor. My goal is to have a very successful snowblower for the winter. 2000Jacobsen 3810: I took off all of the reel blades on the mower and am looking at how to go about transforming it into a snow blower...

The lower front part of my TC45D hood, is broken off and a new hood is over $2,000. It is made of firberglass and I think it would be difficule to mold one with the 3-dimensional curves. If I could find a used hood or a partially damaged hood it would help. Any suggestions?

I've rented the TC35D, and it gets the job done but not efficiently, and makes me smack my head sometimes. I need something relatively the same size to fit on my roads in the woods, I have some room to play here, but would prefer to stay as close to this size as possible. My purposes/usages...

New to TBN and this is my first post. I bought a NH TC45D with a 16LA Loader and a Bradco 509 backhoe. The tractor has 1600 hours and the backhoe has little use. When I bought this package it was for the right price since the rear transmission was trashed. The case has been broken on one of...

I recently bought a New Holland TC45D used from the local tractor dealer. No idea how many hours are on it because the meter tends to spin different speeds and directions depending on the RPM I happen to be running. It isn't a perfect machine but for the price I paid I am willing to put up...

Y'all I have recently purchased a NH TC45D SS 17LA, originally thought to be a 2002, but it turns out was made in 2000. I paid 16,500 and it has 1200 hrs. I have learned much from this forum, and hope to contribute in the future, but I am still learning. I will be using it to load, unload...

Y'all I have recently purchased a NH TC45D SS 17LA, originally thought to be a 2002, but it turns out was made in 2000. I paid 16,500 and it has 1200 hrs. I have learned much from this forum, and hope to contribute in the future, but I am still learning. I will be using it to load, unload...

Some moron put gasoline in my diesel tank and I cannot find a fuel tank drain on the bottom. Any one have any ideas as to how I can drain the tank. I found the fuel outlet line, but if I unhook that line diesel will run out all over the tractor before I could get a hose on it. I would...

Does anyone know if there would be any significant problems with installing a John Deere 47 Backhoe on my TC45D tractor? My main concern would be having to go through a bunch of work every time I installed the backhoe. Thanks.

Well this is for friend of mine I told him I would do some research. he needs new tractor for his golf course. he will be using it for pulling gang mowers and snowblowing and dirt work with loader. he only has JD 750 now like 25 Hp. he wants something bigger but not too heavy. I know all...

I had been comparing an L4630 and an MX5000 for my 60 acre horse farm. I haven't used HST before but I got a chance to spend some time on a 4630 HST yesterday. I'm not kean on the pedal arrangement, but I like the idea of HST. The problem is using the brakes to make a tight turn. The MX5000 has...

OK the neighbor is looking at hydro CUTs. He does not like the pedal on the Kubota,so it is scratched from his list. The local CIH dealer sells Kubotas,so he does not sell the DX. The local MF and Agco dealers are way too high on price. The TCD with loader is priced at $35,000 CDN for a brand...

When I purchased my TC45D, I got the option to later purhase the Woods BB720 Cutter (medium duty) at a good price. In looking at the the unit now, the dealer and I tend to think this is too much for the tractor (cutter weight is 1,140lbs). Standard duty Woods BB72 is 702lbs. I have a lot of...