new holland tz25da

New holland would run intermittently and finally gave out. No glow plug light, no crank. Cleaned both fuel filters. Has cracked flasher unit but not seeing how or if that would be the culprit. Any advice on what to check next? Have crank when jumping selenoid btw. Thanks!

Does anybody have any lead on 'parts tractor with a good transmission'. Backing my snow blower into a snow bank, I blew up transmission cassing/totaled. I've been looking I can't find anything. This little tractor is too good to be a parts tractor. Thanks

Checked all safety switches...all ohm properly. Headlights work. When ignition switch is turned on glow plug light do not illuminate and starter does.not engage. Battery fully charged. Fuses all check out good. What am I missing? Nearest repair shop is 75 miles...and they start charging on...

Hey all, Looked under the hood of my tractor the other day and noticed the coolant level was about 1/2" below the min mark. Went into my manual and saw FGCC2701DS for the P/N and after some research noticed that the P/N was superseded by CC2820. I researched this and the fluid I have now is...

Looking for some advice on which tractor to purchase. I plan on using it to spread loam, plow small driveway and use forks (with spade attachment for small digging jobs). I found 2 tractors that are in my price range. Neither of them will budge on price but it looks like a fair deal for either...

hello all, need some help here. Thinking of replacing my 2008 NH tz25da 4x4. She only has 750 hours, has a 60 belly mower and a bush hog front end loader. I really like my new holland but all of a sudden she's 9 years old. I wouldn't be opposed to another New Holland but wanted to see what...

This tractor has 575 hrs, front end loader and 60" mid mount mower deck. Owner crashed it into a tree and dented the hood pretty good but it does open and close. While checking the engine out I noticed the oil fill cap was missing. The elderly owner didn't realize it and it looks like a...

Looking for ideas to add a quick release/attach for the loader/bucket for the NH 10LA. I have heard the kubota quick attach for the BX series works but looking for ideas in case this wont work

Looking for ideas to add a quick release/attach for the loader/bucket for the NH 10LA. I have heard the Kubota quick attach for the BX series works but looking for ideas in case this wont work.

Hello all, I am a newbie to the hydraulics area of tractors and I could use some advice. I have a New Holland TZ25DA without any additional hydraulics installed beyond the 3 point hitch valve. I recently acquired an old FEL off of a Farmall C tractor. This was operated using a belt driven...

I own a TZ25DA, and I need to replace the front wheel seal. I have the tire off, and all of the bolts have been removed from the housing that contains the seal. I am having a difficult time removing the hub, and I don't want to force it because I'm worried that the shaft is being held in by a...

hello, looking to trade in my 08 tz25da I have a front end loader and 60 belly mower. She now has about 400 hours on it. She's in good condition. Just thinking about upgrading newer to the same thing or bigger. What is mine worth and what should I get? I really like my new Holland and would...

Hi folks, About my TZ25DA, 4 years in, backhoe, 48" lawnmower, back blade. I like it, emotionally attached to my 'Little Blue', the engine is great ... HOWEVER: - Next to Zero power in 'Hi' a 5degree grade is too much - Zero power in 'Hi' reverse.... a softball size hump is enough...

Everyone, I have used this forum on many occasions and have always received a warm welcome along with great suggestions and advice for troubleshooting. Now we have sold our farm and are going to become 'city slickers' in another state and we need to sell our New Holland tractor along with a...

Hey guys thanks again so far for all the great advise. I am currently looking at 2 tractors. One is a 2006 JOhn Deere 2305 with 62" MMM and loader with about 250 hours on it. That one is about 11,000. And also a 2008 New Holland TZ25DA with only 81 hours on it. This one also has a loader...

Hello I am looking for a snow plow for my tz25. I have a bush hog front end loader on now. I would be open to a snowplow that mounts onto the loader or one that mounts to the tractor with the loader off. I don't think bush hog makes any. What snowplow would work good on my plow? Any ideas?

Did / Does NH make a weight bracket for the front of the TZ SCUTs? Would like one that holds the 41lb suitcase weights.

I was on here looking for some instruction for front weight ballast for my tractor,but couldn't find anything on the whole internet. So...I made my own to balance my 5' county line tiller. This is what I came up with.