rotary cutter gearbox

I just bought an older ford rotary cutter. It is missing the top half of the gearbox and the pto shaft(I bought the thing for $60). The best I can tell the model number on the tag of the whole thing is 22-151. I’m having trouble finding the correct gearbox for it. The output shaft is 10 spline...

I picked up a tractor recently that came with a Hi-Co rotary mower. The PTO and shaft spin at full speed, but the blades don't move at all. They will turn if I reach underneath and push them by hand. This is the first rotary mower I have owned so I know virtually nothing about them. Should I...

I purchased a used Rhino 10' brush hog last fall to use this year. I have broken the output shaft clean in to. There appears to be no rust on the shaft where it broke, but there are no stumps, just old rotten oak limbs out in the horse pasture. This is the second shaft I broke in two weeks...

Ok gents…here goes. I have a 2022 Woods 84” Rear Discharge Mower TKP84.40 (TurfKeeper Pro), and despite my trying the gearbox keeps getting water in it. I know it’s water because the gearbox oil is milky. It was recently replaced, as was the o-ring for the vented dipstick. I first noticed the...

The output shaft on my MX6 rotary cutter broke and is stuck in the stump jumper attachment. When I look at the manual/part diagram, it appears that I should be able to drive the broken shaft with a sledge back out towards the broken side. I have not been able to do so. The cutter is about 9...

Hi Guys, Buying a new gearbox for a rotary cutter rebuild project but am confused on which one I need. Searched the internet a lot but can't seem to find information I need. I have a gearbox picked out but there are two versions; CW input/CW output and CW input/CCW output. I see other...