trctr155
Bronze Member
Can't blame your frustration. Especially for that kind of money.
Backhoe 110 TLB Stabilizer Shields
- Thread starter V1BuzzBomb
- Start date
- Views: 5135
OP
V1BuzzBomb
Silver Member
Note that if you install the Stabilizer Shields, in time, they will contact the Stabilizer feet. As they have nowhere near the girth of anything else involved, I expect that they will certainly peen and perhaps otherwise distort and deflect from load. To avoid that, I notched reliefs. I did so in the the feet. As I already had them installed, this was my choice but certainly not first had I known and they weren't installed.
If you opt for them, test fit with cleat down and foot seated to Stabilizer arm. Mark a notch and relieve in advance. I advise relieving shield.
If you opt for them, test fit with cleat down and foot seated to Stabilizer arm. Mark a notch and relieve in advance. I advise relieving shield.
Attachments
OP
V1BuzzBomb
Silver Member
Re: 110 TLB Skid Plate
I finished install of skid plate. I find that the forward part of the skid plate inner lip contacts the welds and not the lower flats of the rear side frames. That leaves a gap to GR's front lower drop brackets. Rather than drawing up the gap, I installed automotive body shims. If/when at some point I have this skid plate off, I may grind relief on the front upper inner lips of the skid plate to lay flat on the side frames.
I finished install of skid plate. I find that the forward part of the skid plate inner lip contacts the welds and not the lower flats of the rear side frames. That leaves a gap to GR's front lower drop brackets. Rather than drawing up the gap, I installed automotive body shims. If/when at some point I have this skid plate off, I may grind relief on the front upper inner lips of the skid plate to lay flat on the side frames.
