1965 Ford 4000 Backhoe

[TractorTech]

Ford 4500 front pump was a Vickers V33iP17G15B20C

 

[cbg8670]

Also ask over at yesterday's tractors. There was couple guys there. That knew all about the old industrial Ford s

 

[ajc209]

NO PTO or either of the two engine "standard" driven PTOs near drivers seat. This is a unique beast. The whole system is driven off this single pump.

I think I can make this work. I need to call to verify dimensions.

OEM Vickers 25V21A-11D-10L-153 Hydraulic Vane Pump 21 GPM @ 1200 RPM 4.12 cu.in​

I just need to get a new 4 bolt flange and threaded pipe. Large reservoir in front of engine feed straight down into pump. Pump feeds out to the passenger side. Im not sure if all the heavy duty 4000s are like this but almost the whole frame is the hydraulic reservoir.

I would like the ease of swapping in identical pump but realized that would probably not happen. I am hopeful above pump fits because there is almost no room. Cant really butcher to fit something in since it is all frame or at least 1 " thick cast material around current pump location. Pump is driven off shaft mounted directly to crank.

Hopeful above recommended hydraulic filter fits as well. This filter sits in the reservoir in front of engine. I could eventually plumb in an inline filter somewhere but no place screams out to be convenient so sticking with factory would be easiest.

thanks all for the help.

 

[ajc209]

Ford 4500 front pump was a Vickers V33iP17G15B20C

thanks! I will look into this. It appears exactly the same

 

[TractorTech]

Here is the hydraulic system you should have. The pump pictured is a gear pump with the 4 bolt pump lines. The filter is in the top tank and the loader frame completes the reservoir.

Make sure you inspect the drive crosses for wear. Grease the crosses before installing if not worn.

 

[ajc209]

Here is the hydraulic system you should have. The pump pictured is a gear pump with the 4 bolt pump lines. The filter is in the top tank and the loader frame completes the reservoir.

Make sure you inspect the drive crosses for wear. Grease the crosses before installing if not worn.

Thanks, I really appreciate the help. I looked all over for this stuff and appreciate you guys helping out here.