3-point hitch lever on L2650 - how to adjust? Keeps falling.

   / 3-point hitch lever on L2650 - how to adjust? Keeps falling. #1  

SouthernSky

Silver Member
Joined
Jun 10, 2005
Messages
205
Location
Deville, LA
Tractor
2013 Kubota L3200DT
The lever to raise and lower my bushhog or box blade keeps drooping down/forward instead of staying in one position, thereby causing the implement to go lower than I want it to because of whatever weight is attached to the three point hitch.

How do I adjust the lever so I don't literally have to hold it? Is there an adjustment screw? Is it tied to the PTO turn handle under the seat?

Thanks in advance!
 
   / 3-point hitch lever on L2650 - how to adjust? Keeps falling. #2  
I had the same issue with an L3400HST, but found out tightening the nut wasn't the issue. Instead, the lack of friction was due to a broken washer. If your L2650 is similar to my L3400, you can see my post Replacing Friction Plate Feed Back earlier and in the attached PDF file you will need to loosen part # 90, tighten 80 to your taste, and then tighten 90 back up.
 
   / 3-point hitch lever on L2650 - how to adjust? Keeps falling.
  • Thread Starter
#3  
Interesting. Mine doesn't quite look like the same design but it was worth a look for sure. Thanks for the reply!

I'm open to any suggestions.
 

Tractor & Equipment Auctions

2022 Bobcat T770 Track Skid Steer (A49339)
2022 Bobcat T770...
2007 Toyota Corolla Sedan (A46684)
2007 Toyota...
2014 UTILITY 53X102 DRY VAN TRAILER (A45678)
2014 UTILITY...
Wood Pro 20D169 Wood Chipper (A43476)
Wood Pro 20D169...
2018 Ford F-150 4x4 Ext. Cab Pickup Truck (A46684)
2018 Ford F-150...
ATTENTION! PLEASE READ (A47307)
ATTENTION! PLEASE...
 
Top