3-pt question

[Ym1401King]

If you look at the 3-pt that TractorErnie manufacturers, you will see a pin that is threaded on one end, and goes into the lift arms of the tractor, which attaches an adjustable arm, with a ball end to, the said pin and goes to the lift arms. I want to know where to get the said pin. I hope you can understand this.


Aric
YM1401/w3tcompact/icons/king.gif

 

[Ym1401King]

Just to let all know, I took the initiative myself to have made the following pin that I was asking about. I took 2 pieces of hardened, and cold rolled 1"x 4", to the local machine shop, and for $20 each, they turned them down to 7/8" diameter, with a 1/2" threaded end on each of them. More than I want to spend, but it will work great.

Thanks for the thoughts anyway.

Aric
YM1401 /w3tcompact/icons/king.gif

 

[Anonymous Poster]

Eric
I sell those pins
2 for 15.00
You should of called me
Oh well,Im glad that you found them.
I havent heard from you or your father in a while
Take care, Tractor Ernie

 

[Ym1401King]

Sorry, Ernie. We have been busy building his house. He is using his tractor to run a 6' finish mower right now, and it works the guts out of it. He also, has the loader on it, and it has worked great for backfillling. I have NO problems with my 1401. I love it. It stays in its nice little shed, and keeps covered from the sun. I am just debating on putting a 4 or a 5 ' rear blade on my 1401. Not sure.

Aric
YM1401 /w3tcompact/icons/king.gif