pane056
Silver Member
Hello;
I have a 3320 w/ 300 CX loader with heavy duty bucket. I'm having problems with the Quik Atach. A while back I bought a 48" Grapple. It could not be attached because one of he pins was left of center of the mating hole on the loader. The dealer ground about 1/8" off one side of the pin and all was o.k.
Yesterday I tried to reattach the bucket. Same problem. Now the bucket pin is higher then the hole. I figured the dealer had it installed so it had to go on. Wrong. Everything I tried failed. I Detached and REtached a dozen times.
Exactly the same problem on every reattach. The loader bracket is bottomed out on the underside of the top bucket hook. If I grind the hole a little in the bucket mounting bracket it will work just fine. I don't really want to do that because it was mounted properly previousley. When I disconnected the bucket it did not hang up but came off properly.
trhanks. nicholas
I have a 3320 w/ 300 CX loader with heavy duty bucket. I'm having problems with the Quik Atach. A while back I bought a 48" Grapple. It could not be attached because one of he pins was left of center of the mating hole on the loader. The dealer ground about 1/8" off one side of the pin and all was o.k.
Yesterday I tried to reattach the bucket. Same problem. Now the bucket pin is higher then the hole. I figured the dealer had it installed so it had to go on. Wrong. Everything I tried failed. I Detached and REtached a dozen times.
Exactly the same problem on every reattach. The loader bracket is bottomed out on the underside of the top bucket hook. If I grind the hole a little in the bucket mounting bracket it will work just fine. I don't really want to do that because it was mounted properly previousley. When I disconnected the bucket it did not hang up but came off properly.
trhanks. nicholas