3032 help

[ericsloan]

I have a 3032 and in need od some help, after parking one day tried to start again but starter just barely tries it never makes 1/4 rotationand stops. I am assuming all sensprs are made because it tries the voltage starts then goes to 11.5vdc on two batteries im thinking connections at starter does anyone have outher ideas.

 

[beenthere]

Clean all battery cable connections for starters, what I'd suggest.
Then get the battery load tested.
If older than 4 years, suspect new one needed.

Dig deeper if still a problem. .....just my initial ideas..

 

[Roadworthy]

I'll go along with "beenthere" but add you should be sure battery cables are properly tightened and trace your ground wire to the frame. Clean it and make sure it's tightned securely.

 

[Spindifferent]

Have you tried to jump-start the tractor from another vehicle or a battery booster? If a jump-start works to start the engine, you need a new battery. If the jump-start does not work, look elsewhere for the issue with electrical cables, connections, starter motor.

Good luck!

 

[Streetcar]

My issue was bad ground