4110 3pt hitch measurement needed, please

[2nstonge]

I ordered a CCM tiller yesterday (& a landscape rake, too), so that the good folks at CCI can cut the PTO to the correct length & ship everything I need the measurement from the base/stub of the rear PTO drive to the midpoint of the centerline of the lower draft links mounting point - draft links must be level in the horizontal position & at a 26" spread.
I took delivery of the 4110 in December, the BH was attached & I'm just realizing the dealer didn't leave the 3pt hardware or the ballast box! I must've been too excited to notice. I've had no reason to remove the BH until now & I can't connect with the dealer until Saturday...any help would be great!

Thanks much, -Norm

 

[RalphVa]

I measured my 4010 this afternoon. It should be the same as the 4110. It was 21 3/4" from the end of the PTO to the mid point of the drawbar between the lift arms with the drawbar near horizontal. The drawbar is 26" wide.

Ralph

 

[2nstonge]

Thanks Ralph, I appreciate it!

-Norm

 

[Hypernix]

Hello,

Don' knowt if you still need some measurements, I took the following on my 4110.

From the end of the PTO shaft on the 4110 to the end of the lift arms I had 22.5"

I also measured the two PTO shaft I use:

Tiller (Bhuller Farm King 60") PTO shaft
Fully expanded = 32"
Fully retracted = 26"
Tiller side of the PTO shaft = 15.5" (attached to a slip clutch)
Tractor side of the PTO shaft = 20"

Snow Blower (Pronovost Puma 54") PTO shaft
When attached to the tractor = 33"
When fully retracted = 29.5"

I also took a few photos and will post them following this post!

Hypernix

 

[Hypernix]

This picture shows the Tiller PTO shaft fully retracted.

Hypernix

 

[Hypernix]

This one shows the PTO Shaft extended...

Hypernix

 

[Hypernix]

This one shows the end of the PTO Shaft that connects to the tractor... It uses a sliding "bucle" Not sure if this is the exact term, but it seems to be more heavy duty than the pin used on the Snow Blower Shaft.

Hypernix

 

[Hypernix]

This one shows the tiller end of the PTO Shaft attached to a slip clutch...

Hypernix

 

[Hypernix]

This one shows the end of the PTO Shaft that connects to the tractor end and which I use with the Snow blower. Notice the pin used to lock the PTO Shaft...

Hypernix

 

[Hypernix]

And finally a picture of the PTO Shaft attached to the tractor and the snow blower.

Hypernix