47" Snowblower Rebuild

umityesil · Nov 6, 2020

I think you must look at the throttle and cable area.

BCWoodtick · Nov 6, 2020

Looks like most of the parts are standard so I'm just trying to confirm from back of fan to sprocket orientation? The first pressed flange will have the raised portion in the hole of housing then bearing then next flange then locking collar? The old hole in housing is so distorted that I'm trying to figure out size of hole to drill? I'm assuming it's the outer diameter of the raised portion of the pressed flange?

Thanks

BCWoodtick · Nov 6, 2020

This is a picture of distressed portion and why I'm replacing that steal.

sriddle1 · Nov 7, 2020

I just purchased a used 47" and found this, hope it helps

Kish318420 · Nov 7, 2020

BCWoodtick said:
This is a picture of distressed portion and why I'm replacing that steal.

Wow that took a beating, the cracks around the bolt punch outs are amaazing.

BCWoodtick · Nov 7, 2020

Ya I'm hoping once I get it going again I'll get another 15 years out of it? I will try and be a little less abusive with it and should be able to as have a bigger Kubota to do the heavier snow work in winter now.