I have a new 5075E with 10hrs on it and I noticed a hydraulic leak where the handle for the rear remote SCV inserts into the axle housing. More fluid seems to leak when I raise pull the handle up past the float position. I noticed that the bush hog pull-type does not stay raised as well while connected to the rear SCV. Please help
5075E rear SCV leak
- Thread starter GreenBean
- Start date
- Views: 4775
-
- Tags
- john deere 5075e
AKfish
Super Member
- Joined
- Oct 1, 2004
- Messages
- 5,419
- Location
- Alaska
- Tractor
- JD 5115M; JD 110 TLB; JD 4720; Ford 9N; JD X300R
Welcome to TBN, GreenBean. Ten hours, huh? Well, that's a bit frustrating, I'm sure... One good thing about it, though - under warranty - and the onus in gonna be on your dealer to get things right.
I looked here for a parts diagram of your rear SCV - John Deere - Parts Catalog
Too bad it doesn't show an exploded view of the valve body. However, if I'd have to venture a guess; I'd bet that there's an O-ring just below the cap (with 2 bolts) that the shaft fits into at the top of the valve.
Should not be a difficult or too expensive a fix - IMO.
AKfish
I looked here for a parts diagram of your rear SCV - John Deere - Parts Catalog
Too bad it doesn't show an exploded view of the valve body. However, if I'd have to venture a guess; I'd bet that there's an O-ring just below the cap (with 2 bolts) that the shaft fits into at the top of the valve.
Should not be a difficult or too expensive a fix - IMO.
AKfish
mjncad
Super Member
Welcome. That's what the warranty is for...let the dealer fix it.
After looking through parts catalog the leak is where the hydraulic oil supply line (14) inserts into the rockshaft there are two o-rings between the line and elbow(27) that inserts into the rockshaft. It leaks when using FEL, 3PH, and rear SCV. Anyone else have this problem?
