cup149
Silver Member
- Joined
- Feb 25, 2001
- Messages
- 128
- Location
- Slate Lick, Armstrong Co, PA
- Tractor
- International 300 Utility, BX2200
Re: 60\" MMM Blades
I use a torque wrench.
Mike
I use a torque wrench.
Mike
60" MMM Blades
- Thread starter theboman
- Start date
- Views: 2910
Jeff396
Veteran Member
Re: 60\" MMM Blades
Yup, me too. If they give a spec I'll use a torque wrench. /forums/images/graemlins/smile.gif
Jeff
Yup, me too. If they give a spec I'll use a torque wrench. /forums/images/graemlins/smile.gif
Jeff
Charliebrn
Platinum Member
Re: 60\" MMM Blades
Yup, me too! /forums/images/graemlins/smile.gif Those slip washers wont work properly unless the nuts are torqued as spec'd.
Yup, me too! /forums/images/graemlins/smile.gif Those slip washers wont work properly unless the nuts are torqued as spec'd.
Jeff396
Veteran Member
Re: 60\" MMM Blades
Thanks to all for the help. I got a set of blades today for around $32.00 at my local dealership. I also got a 30 mm socket at the discount tool place for $2.00. It's not an impact but for that price it will be used as one. They had impacts for about $12.00 but they were 3/4 inch drive as opposed to 1/2 inch drive. Tomorrow is blade changing day! /forums/images/graemlins/smile.gif
Jeff
Thanks to all for the help. I got a set of blades today for around $32.00 at my local dealership. I also got a 30 mm socket at the discount tool place for $2.00. It's not an impact but for that price it will be used as one. They had impacts for about $12.00 but they were 3/4 inch drive as opposed to 1/2 inch drive. Tomorrow is blade changing day! /forums/images/graemlins/smile.gif
Jeff
OP
theboman
Veteran Member
Re: 60\" MMM Blades
No torque here.
No torque here.