My 6210 has always started right up. Has been parked for a couple weeks and now won't start, doesn't fire at all. Must not be getting fuel. Checked all the wiring for rat chewing and everything looks fine. What should I do to check if I'm getting fuel where it's needed? Thanks
6210 Won't Start
- Thread starter Believer
- Start date
- Views: 6655
sisupower
Silver Member
Need to make sure your getting power to transfer pump and see if it's working.
sisupower
Silver Member
I've had some have a air lock drawn into supply line between tank and main filter.
Last edited:
When you turn the key on, you should hear the electric transfer pump in the tank humming. Try loosening the bleed screw on the fuel filter with key on and see if fuel squirts out. If it does, then follow the fuel line from the filter to the injection pump. Loosen the fitting at the pump with key on until you get good fuel flow. Then loosen a couple of fuel lines leading to the injectors and crank engine and see if you get any fuel. If you do, tighten the fittings and crank some more. Engine should start. SOunds like the fuel may have drained back while sitting. Actually before you do all that, I should have said to check for 12 volts going to the fuel shut off solenoid on the pump. If not then check for blown fuses.
sisupower
Silver Member
Yes what jd110 has stated. I've had a similar issue and had to install a check valve so the supply line would not bleed back to take. Keeping it primed and air out of system
