914MMM Trick

thcri · Jun 18, 2003

When mowing in taller grass my 914MMM would leave windrows off the side of the chute about 2 feet out. I got myself two really thick flat washers and laid them on each end of the spring plate to lift the chute up some. Man did it make a difference. It was throwing grass out 7 feet. No windrows. I think I will make the washers permanent. But I caution you all as I am sure there is some safety issues there with the chute pointed down some. the washers were about and 1/8" thick each

Murph

TOMLESCOEQUIP · Jun 19, 2003

Murph.........I'll probably get some greif over this..........but the chute for my 914 6' MMM is lying in my shop under the workbench.........Adding the washers there probably won't make a difference but I could try.............TOM

Anonymous Poster · Jun 19, 2003

Murph,
How did you get those washers to stay in place? My chute bounces so much, they would fall out in a matter of seconds!

thcri · Jun 19, 2003

The heaby spring on my chute keeps mine tight. I have no problems keeping them there. I think a person could put some clear caulk on the bottom side of the washers and then it could bounce all it wants. If you need to remove them you would still be able to. Just a thought.

murph