A CARPENTER????
- Thread starter Williy
- Start date
- Views: 2191
Thomas
Epic Contributor
- Joined
- Apr 6, 2000
- Messages
- 31,926
- Location
- Lebanon,NH.
- Tractor
- Kubota B2650HSD w/Frontloader & CC LTX1046 & Craftman T2200 lawn mower.
Not just carpentry either.
Hay Dude
Epic Contributor
- Joined
- Aug 28, 2012
- Messages
- 25,868
- Location
- A Hay Field along the PA/DE border
- Tractor
- Challenger MT655E, Massey Ferguson 7495, Challenger MT555D, Challenger MT535B Krone 4x4 XC baler, 2-Kubota ZD1211’s, 2020 Ram 5500 Cummins 4x4, IH 7500 4x4 dump truck, Kaufman 35’ tandem 19 ton trailer, Deere CX-15, Pottinger Hay mower, NH wheel rak
Looks like he may have been using the saw to get a nice starter slot going, then return to the ladder to finish it.
I’ve done that. No biggie.
I’ve done that. No biggie.
Last edited:
chim
Elite Member
A tinknocker bud told me this story years ago and insists this is true:
Two guys he was working with on a project were on a scaffold installing a run of duct. For some reason they couldn't reach what they needed to so they slid one plank outside of the scaffold frame for #1 tinknocker to stand on while #2 remained on the scaffold to be a counterweight. All was well till #1 said "Gimme a hand".
Two guys he was working with on a project were on a scaffold installing a run of duct. For some reason they couldn't reach what they needed to so they slid one plank outside of the scaffold frame for #1 tinknocker to stand on while #2 remained on the scaffold to be a counterweight. All was well till #1 said "Gimme a hand".
lilranch2001
Super Member
- Joined
- Nov 25, 2009
- Messages
- 9,055
- Tractor
- Bobcat CT 235
On one hand, I’ve worked with a lot of tin knockers, so it could be believable, but I’ve also met some of the best tradesmen in the world being tinners!
chim
Elite Member
Yup. The company I retired from had all the trades, but we were heavy on electrical and mechanical. All trades have both Einsteins and Gomer Pyles
lilranch2001
Super Member
- Joined
- Nov 25, 2009
- Messages
- 9,055
- Tractor
- Bobcat CT 235
I’ve seen some works of arts, created by a good tinner!Yup. The company I retired from had all the trades, but we were heavy on electrical and mechanical. All trades have both Einsteins and Gomer Pyles
Hay Dude
Epic Contributor
- Joined
- Aug 28, 2012
- Messages
- 25,868
- Location
- A Hay Field along the PA/DE border
- Tractor
- Challenger MT655E, Massey Ferguson 7495, Challenger MT555D, Challenger MT535B Krone 4x4 XC baler, 2-Kubota ZD1211’s, 2020 Ram 5500 Cummins 4x4, IH 7500 4x4 dump truck, Kaufman 35’ tandem 19 ton trailer, Deere CX-15, Pottinger Hay mower, NH wheel rak
He may have also lost his carpenter’s pencil and is using the saw to mark the rafter, joist, beam, etc.
