Adding additional Hydraulic hookups?

[Birch Hill Farm]

Im new to farming and tractor use so, this might be a dumb question. Can I add additional hydraulic hook ups to our International 444 to run implements that require hydraulic use? I would like to upgrade from our very old sickle bar to a newer disk mower that requires the hydraulics to raise and lower it from the horizontal position. Is this possible? I know some of the 444 had FEL so is there a way to utilize this ability for other implements or is it a different system for non FEL like our tractor? Thanks for the replys!

 

[cyrush]

Hi again i assume from your question you have no auxiliary hydraulic valves on the tractor at present??

To simply tip a trailer you can use the FEL tapping to provide a single acting service using the levers and control valves already on the tractor.

For extra service you can add 2 extra valves, single or double acting to the manifold on the l/hand side of the hydraulic housing under seat , behind your left knee.

I will find a parts layout with part no's and post later.!!!

 

[Birch Hill Farm]

Thanks for the information and reply! So, would a front end loader use the same controls as the 3 pt hitch lift?

 

[cyrush]

Yes, in its simplest form it could, but this will only give you 1 service, single acting to lift the loader, if you have gravity tip for bucket./fork o/k, if you have hydraulic tip/crowd on bucket then you need extra valves.

You can c still fit a loader valve bank and supply them from hitch valve, without fitting extra auxiliary valves on tractor.

Whats the serial no of your tractor ???

 

[cyrush]

Birch hill farm see atts for info previously discussed, this should answer your questions

I have used the 444 European parts book as diagrams are clearer !!!!

 

[Birch Hill Farm]

Thanks for the information! So, the FEL tapping could be used to flip a hay disk mower from horizontal to vertical position?

 

[cyrush]

Yes providing it only needs a single acting service, ie: hydraulic one way, gravity or springs the other way.

 

[Birch Hill Farm]

Thanks for the schematics and information!

 

[Birch Hill Farm]

Revisiting an old thread. Im looking at getting a vermeer 504 roll baler to use with our international 444 just for a while until we get a bigger tractor. What hydraulic hook ups are needed to get this to work? I have not yet pursued adding additional hookups as I was asking about at the start of this thread but, with the purchase of the baler I will need to. Thanks for any info on this.

 

[cyrush]

What services does your baler need??? As the tractor was only designed to support 2 services!!also when built the systems were not really meant to be used as a continuous flow/return system ??