jb15426
New member
I need a post driver. Kencove, Rhino, and others have drivers. Some are air driven while other are hydraulic. New vs used? Advice?
JohnB
JohnB
Advice needed on post drivers
- Thread starter jb15426
- Start date
- Views: 1181
RedNeckRacin
Elite Member
- Joined
- Jan 6, 2008
- Messages
- 2,506
- Location
- Western PA
- Tractor
- John Deere 5083E MFWD, Kubota L3400 HST
What are you running the driver with?
RedNeckRacin
Elite Member
- Joined
- Jan 6, 2008
- Messages
- 2,506
- Location
- Western PA
- Tractor
- John Deere 5083E MFWD, Kubota L3400 HST
Sounds like your going three point hydraulic to me then. If your pretty handy fixing things or don't mind tweaking items, a used one may be the way to go. The new options go from basic to wild.
DJ54
Elite Member
- Joined
- Jan 20, 2009
- Messages
- 4,631
- Location
- Carroll, Ohio
- Tractor
- IH Farmall 656 gas/ IH 240 Utility/ 2, Super C Farmalls/ 2, Farmall A's/ Farmall BN/McCormick-Deering OS-6/McCormick-Deering O-4/ '36 Farmall F-12/ 480 Case hoe. '65 Ford 2000 3 cyl., 4 spd. w/3 spd Aux. Trans
I bought my Shaver HD-8, full hydraulic tilt, used on Ebay, for less than half of a new one. Did have to replace a spring after driving about 100 posts. Got that through Kencove, who's were about half, compared to a Shaver OEM. Other than the spring, no problems with it, and it drove about 400 posts.
I'd recommend getting the hydraulic tilt. Well worth the extra money, as you'll need to do some tweeking as you drive. Sure beats cranking..!!
I'd recommend getting the hydraulic tilt. Well worth the extra money, as you'll need to do some tweeking as you drive. Sure beats cranking..!!
sweettractors
Advertiser
We have a used Danuser hydraulic drive unit on Ebay. Can be seen in the link below. Ken Sweet
Used 8 in Danuser Post Driver 3 Point Our Low Cost Shipping Is Amazing Fast | eBay
Used 8 in Danuser Post Driver 3 Point Our Low Cost Shipping Is Amazing Fast | eBay
