Aftermarket or good 12" Front wheel rim to fit Mahindra Max26/28 needed?

[mike69440]

Comical what Mahindra direct dares to ask for a tiny 12" steel rim. These rims have a 80mm center hub fit diameter, 5 lug bolt holes, 1/2" holes on a 4.5" bolt circle, fits 23x8.5-12 R4 tire.
Does anyone know where I can get a useable rim?
Thanks

 

[SPYDERLK]

Try TSC. The width you will need probably makes it special.

 

[mike69440]

Try TSC. The width you will need probably makes it special.

It is the 80mm centering hub fit that is the problem. The most common is 3" that I can buy on Amazon, but it would be a lot of careful grinding and trial fittings to open to 80mm.

 

[SPYDERLK]

It is the 80mm centering hub fit that is the problem. The most common is 3" that I can buy on Amazon, but it would be a lot of careful grinding and trial fittings to open to 80mm.

For a low speed application I dont see any need to worry about the center - just make it big enough. The lugs, esp if tapered, will hold the wheel securely. -- The fronts on my 7520 with loader do not use taper lugs, yet do not move on the hub in the slightest, even though there is some center hole clearance.