Anyway to adjust bucket level indicator?

   / Anyway to adjust bucket level indicator? #1  

Machinewars

Member
Joined
Jul 19, 2013
Messages
46
Location
Chapel hill, nc
Tractor
CX2510
My bucket level indicator at level still has about 2 inches over the top. I don’t see how to adjust it. Is it meant to be cut flush at level?
 
   / Anyway to adjust bucket level indicator? #2  
There's surely something simple going on. I've owned some that were more or less 'precise' but IMO 'close counts'. Got pics?
 
   / Anyway to adjust bucket level indicator? #3  
I cut mine flush at level
 
   / Anyway to adjust bucket level indicator? #4  
My bucket level indicator at level still has about 2 inches over the top. I don’t see how to adjust it. Is it meant to be cut flush at level?
They are meant to be cut flush.. However, might I recommend using different colored 'band' (paint, tape, etc) to mark level for your different implements since thay are all at a different level, usually? Like a red line for your bucket, blue for your forks, yellow for the grapple, etc.. Then mark the top center of each implement with the corresponding color so you can see it from the seat.

Obviously if 2 or 3 are close enough you mark them the same color.
 
   / Anyway to adjust bucket level indicator?
  • Thread Starter
#7  
Thank you! I haven’t thought of different implements having different levels.
 
   / Anyway to adjust bucket level indicator? #8  
If it's a rod sticking out of a tube temporary marks may wear off soon, but cross-holes could be drilled in the same locations. File or grind grooves in the rod to hold paint longer? I had a tube-type with a slash cut at the top of it and little slop o'all. (NH 7308) There was just enough 'tweak' between the rod's end being at the top or bottom of the slash. IMO newer NH CUT indicators are crap & too sloppy. (T-110L, other millennials) I plan on copying the older style and refitting two of my NH FELs.
 
   / Anyway to adjust bucket level indicator? #9  
I use tape too to mark different positions that I value.
 
   / Anyway to adjust bucket level indicator? #10  
My bucket indicator is a tube and rod. I had the same issues you have, and did not want to cut the rod. I put a piece of 3/4" pex with a notch cut out on the tube. With the bucket on the ground and level adjust the pex so the rod is even with the end. The notch in the pex is so you can see how far below level the rod/bucket tip is.
C5C32F6E-95F9-46D2-B40C-D10FDE7AA931.jpeg
 

Tractor & Equipment Auctions

2015 JOHN DEERE 5100M TRACTOR (A51243)
2015 JOHN DEERE...
2016 Chevrolet Silverado 1500 Crew Cab Pickup Truck (A50323)
2016 Chevrolet...
2004 Dodge Dakota Ext. Cab Pickup Truck (A50323)
2004 Dodge Dakota...
BUSH HOG 2810CD SINGLE FLEX WING ROTARY MOWER (A51406)
BUSH HOG 2810CD...
PORTA CABLE 150 PSI AIR COMPRESSOR (A50854)
PORTA CABLE 150...
2018 PETERBILT 567 (A50854)
2018 PETERBILT 567...
 
Top