Rotary Cutter Attach Woods cutter driveline to input shaft

[Bif]

I have a 6 month old Woods HC72C cutter and I just sheared my second driveline bolt. First time, no problem. This time, the driveline has slipped off the input shaft and I can't get it back on. It seems to stop dry about a quarter of an inch from the end of the shaft. Do I just ream out the inside of the driveline until the shaft fits, or is there a trick I need to know?

 

[LD1]

Is it dirt or rusty?? Also could have gotten a ding or but on it when it came off the second time. Peice of emery cloth should do the trick.

 

[Bif]

Nope. No dirt or rust. Still has original grease on it. I don't feel any burrs or nicks. I'll try the emery cloth. Thanks.

 

[Bif]

Anybody know the trick to removing the drive shield on a Woods cutter? I need to work on the driveline.

 

[Baby Grand]

Push in the little plastic grease fitting thingy with a screwdriver and remove it, then spin the shield & slide it off?
That's how I release the shield on mine .