Anonymous Poster
New member
- Joined
- Sep 27, 2005
- Messages
- 0
This was the only frustration on my new BX so far.
We unhooked the PHD and tried to install the rototiller yesterday. After fighting and fighting to get our hands/arms in close enough to try to hook the PTO to the tractor unsuccessfully, son and I took the PTO shield off to get access.
Now I know that shield is important, but do you guy remove/install that thing with each implement change? I didn't.
Or am I missing something simple to make it easier to install?
If there's not a simiple solution, I might fab a shield that just covers the top, to still allow some hand room to do the hookup.
Oh, did you get a PTO shaft cover with yours? I didn't seem to. And is there a shaft cover for the Mid Mount PTO shaft? Didn't find one for that either.
Thanks,
Ron
We unhooked the PHD and tried to install the rototiller yesterday. After fighting and fighting to get our hands/arms in close enough to try to hook the PTO to the tractor unsuccessfully, son and I took the PTO shield off to get access.
Now I know that shield is important, but do you guy remove/install that thing with each implement change? I didn't.
Or am I missing something simple to make it easier to install?
If there's not a simiple solution, I might fab a shield that just covers the top, to still allow some hand room to do the hookup.
Oh, did you get a PTO shaft cover with yours? I didn't seem to. And is there a shaft cover for the Mid Mount PTO shaft? Didn't find one for that either.
Thanks,
Ron