Back Hoe Bucket SCRAPER BLADE prototype

LBrown59 · May 29, 2008

Thanks for he answer.

SkunkWerX said:
The bolts are 1/2" diameter (Takes a 3/4" wrench).

RollTideRam · May 31, 2008

If this works out, will you buy another bx with a backhoe? It sure would save you alot of time, changing all those bolts out. JC

LBrown59 · May 31, 2008

RollTideRam said:
If this works out, will you buy another bx with a backhoe? It sure would save you alot of time, changing all those bolts out. JC

I've already ran into that .
Have the scraper on but need it off to do some digging.

Renze · May 31, 2008

You can make a steel one, weld some clamps that wedge onto the teeth and bucket lip, and use only 1 bolt to make sure it doesnt slip off.

LBrown59 · May 31, 2008

Renze said:
weld some clamps that wedge onto the teeth and bucket lip, and use only 1 bolt to make sure it doesnt slip off.

I like this idea,
Thanks

Willl · May 31, 2008

Renze · Jun 1, 2008

Willl said:
Like this.

http://www.tractorbynet.com/forums/build-yourself/122571-backhoe-bucket-grader-scraper-blade.html

Allmost like that: I would only add two positioning blocks on the outer teeth too to make sure it doesnt swivel and ruin the bolts.

herringchoker · Jun 1, 2008

Here's a sketch of the setup I used for many years when I was digging holes for a living. I used a piece of grader blade.