Bad noises

/ Bad noises #1  

redsput

New member
Joined
Dec 5, 2025
Messages
2
Tractor
Ym 220d and branson 4720h
I hit a stump brush hoggin and the shear pin didn't shear. Every still works, but now there's a definite broken or chipped gear sound from the drivetrain. I idled it slow to the ban and parked it. Thoughts on what it may be,and if it's likely worth fixing? At this point I'd be happy to get her going again even if the PTO is in operable. Any experience that could be shared would be greatly appreciated. Ym 220d
 
/ Bad noises
  • Thread Starter
#2  
Note the sound is from the tractor not the brush hog in case I was unclear on that
 
/ Bad noises #3  
Is this sound only when the pto is engaged or constant? making the noise while idling in neutral? Making the noise only when moving? need more detail.
 
/ Bad noises #4  
Are you using a Overrun clutch? That would be a good place to look if so.

Attachments

  • Rear Axle Int. .jpg
    Rear Axle Int. .jpg
    184.2 KB · Views: 125
This should be the same for the YM220-226 Etc...
 
/ Bad noises #5  
Ouch! Felt that in the seat and the pants is my guess! 220 is this it? FB.Market
1765203746377.png
 

Marketplace Items

2016 F-250 4X4 (A56438)
2016 F-250 4X4...
2014 FORD F150 PICKUP TRUCK (A59908)
2014 FORD F150...
1988 FONTAINE 45' STEP DECK LOADER TRAILER (A60736)
1988 FONTAINE 45'...
INGERSOLL RAND  G25 GENERATOR (A58216)
INGERSOLL RAND...
WBrock Meyer 2000S 70'x12' 2000 BPH Grain Dryer W/Legs&Mill Discharge Sylo,Controller is included (A57148)
WBrock Meyer 2000S...
2005 FRAC TANK 500BBL WHEELED (A60736)
2005 FRAC TANK...
 
Top