Best material used for windshield???

[newbee83]

Hello everyone I have a case 870 Agri King I bought a few months backed.The guy I bought it from rolled it over.Well I managed to straighten the cab as best as i could but now I need to put the windshield back in. The original one wont go back in because there is still a slight tweak in the top of the cab. So I am looking for a good replacement idea??? I think if I use plexiglass it will scratch way to easy so I am leaning to wards lexan. Any info would help a ton. It needs to have some give to conform to the rops .Thanks Again

 

[the bear]

personaly i would get the glass cut ,lexan is good too but does scratch i broke the back window out of my kubota 8950 and put in a new glass one any thing else just wont do in this case , plexiglass scratches too easily and lexan also and will build up with static electricty and bug you for years and the cost of lexan is about the same price as a new windshield

 

[Mickey_Fx]

Not a lot of difference in scratch resistance between acrylic (plexiglas) and polycarbonate (lexan). The acrylic is much more brittle than the polycarbonate. Polycarbonate has some of the best impact resistance of any of the non-filled thermoplastics. Polycarbonate can be purchased with a hard coat that improves scratch resistance.

 

[Dirtnut]

Hello everyone I have a case 870 Agri King I bought a few months backed.The guy I bought it from rolled it over.Well I managed to straighten the cab as best as i could but now I need to put the windshield back in. The original one wont go back in because there is still a slight tweak in the top of the cab. So I am looking for a good replacement idea??? I think if I use plexiglass it will scratch way to easy so I am leaning to wards lexan. Any info would help a ton. It needs to have some give to conform to the rops .Thanks Again

Laminated 1/4 safety glass about $8.25 sq foot.

 

[newbee83]

I would love to put the original glass back in it ( I still have the original glass) But when it rolled it not only tweaked left to right it caused a slight bow as well and we all know what happens when you try to bend glass lol

 

[Cat_Driver]

I used lexan/plexi as a wind shield and on a tractor it cracked from the hrat , sound and the shaking of the tractor. A huge waste of time and money.

 

[Dirtnut]

If it is bent that bad then no glass will work unless it is possible to skin or reskin it with new metal.Other wise plastic is the only way.If you can post a picture it would help,is it glued or in a rubber gasket.I am not sure how clean you want it to look but you could weld some small angle around the edge shim where needed caulk the edge and glue the glass in.Maybe you can use body filler to level it.Need to see what you are dealing with. If it needs to move rubber gasket is the only way even with plastic.

 

[newbee83]

Yes I have the old rubber gasket as well that held the old winshield in , So a gasket could be used. As far as the bend it is about A 1/2 inch bow.Ill try to take some pictures tonight if it is still light out.

 

[kebo]

Just wondering out loud, but if the cab (and the windshield frame) got bent that badly how did the glass not crack/shatter??

 

[BXpanded]

Windshield wipers will ruin Plexiglas or Lexan in minutes. If you have wipers, figure out how to get glass back in there.