POC
Gold Member
I need to replace some broken bolts on my tractor's front axle. They have a 10 on the head, not sure what that means. Any ideas?
Bolt with "10" on the head
- Thread starter POC
- Start date
- Views: 31762
ovrszd
Epic Contributor
- Joined
- May 27, 2006
- Messages
- 33,724
- Location
- Missouri
- Tractor
- Kubota M9540, Ford 3910FWD, Ford 555A, JD2210
Common to see metric bolts with numerical markings. What I pay more attention to is the grade of the bolt in hardness.
Curious why you have broken bolts?
You might want to visit with your dealer parts department concerning these bolts so you get the right grade.
Curious why you have broken bolts?
You might want to visit with your dealer parts department concerning these bolts so you get the right grade.
OP
POC
Gold Member
Dealer went belly up a year after I bought the tractor.
There are 6 bolts, usually. Currently only 3. I guess some worked their way out? And others couldn't handle the strain.
There are no hardness markings that I can see.
Thanks.
OP
POC
Gold Member
flyerdan
Veteran Member
Sure it's not a 10.9? Bolt Head Markings
OP
POC
Gold Member
Yes, there is no ". 9"
OP
POC
Gold Member
The tractor is a Mahindra, made by Mitsubishi, so this is probably correct.
ovrszd
Epic Contributor
- Joined
- May 27, 2006
- Messages
- 33,724
- Location
- Missouri
- Tractor
- Kubota M9540, Ford 3910FWD, Ford 555A, JD2210
Not knowing specifically the bolt's purpose, I'll go out on a limb and recommend Grade 8. Might take one with you to the store so you get the correct size and thread pitch.
OP
POC
Gold Member
That was my plan.
It holds the "down angled part" that the front wheel attaches to, to the main axle.
