Branson tractor 2400 front end loader

[Omatchen]

The hydraulics quick connect 2 of the 4 won't connect on the front end loader . I't the red&white connection.
I can move the green & yellow to red & white it's snaps on fine. I can move red&white to the green & yellow it will
Not snap
New tractor I'm not that familiar with hydraulics

 

[Stimw]

Make sure the connections are clean. They should all be the same.
I had to clean the connections on my pressure washer to get them together. They had surface rust on them.

 

[whis]

might have pressure on them, loosen the fittings a see if they have pressure then try to connect

 

[Omatchen]

Make sure the connections are clean. They should all be the same.
I had to clean the connections on my pressure washer to get them together. They had surface rust on them.

Thanks for your suggestion I located the problem

 

[Omatchen]

might have pressure on them, loosen the fittings a see if they have pressure then try to connect

Thanks for input that was the problem

 

[Texasmark]

On my Branson I have to shut off the engine and run the remote controls through a cycle to get easy engagement. Agree on pressure on one or both sides will inhibit connection.

Mark