bucket forks

   / bucket forks #11  
I wouldn't use the bolt on types on my DX simply due to the very long lever arm that would result from carrying things out in front of the bucket which is already about 4 or 5 inches in front of the loader arms due to the QA setup and the lift arms on the CNH loaders place the whole thing pretty far forward to begin with. If I had forks on the front of the bucket and no weight on the back I think I could almost stand the thing on it's nose picking up one cement block on the end of the forks!

I plan to weld up some QA brackets to weld to the carry-all. It looks to be a pretty simple proposition, presuming my welds are up to the job. The factory plate has bends where I will have welds, but I think that's more for production expediency than anything else.
 

Tractor & Equipment Auctions

2020 JLG 1732 16,755lb 4x4 High-Capacity Rough Terrain Telehandler (A49461)
2020 JLG 1732...
F-500 POWER PUMP 500HP TRIPLEX POWERED BY 3412 CATERPILLAR ENGINE (A50854)
F-500 POWER PUMP...
2019 PJ 25 T/A GOOSENECK TRAILER (A50854)
2019 PJ 25 T/A...
2018 Ram 5500 Bucket Truck 4x4 with Versalift VST40 - 45FT Rotating Bucket and Jib Winch (A51039)
2018 Ram 5500...
John Deere Gator XUV835M 4x4 Utility Cart (A48082)
John Deere Gator...
2016 Ford F550 4x4 Bucket Truck with Altec AT41 - 46FT Rotating Bucket and Jib Winch (A51039)
2016 Ford F550 4x4...
 
Top