goeduck
Super Member
That is exactly the configuration I like. I pull/lift from the center to maintain balance and use the grab on either side depending on where I am standing to secure the chain. Nice job!
Bucket Hooks
- Thread starter WranglerX
- Start date
- Views: 33891
That is exactly the configuration I like. I pull/lift from the center to maintain balance and use the grab on either side depending on where I am standing to secure the chain. Nice job!
BRMyers
Platinum Member
Since I can't weld, I went with the old Bolt-on Hooks from Ken.
k0ua
Epic Contributor
Well, Ken did a nice job of welding them, and you did a nice job of installing them...They look great.
Blstr88
Silver Member
Where did you order those ?
OP
WranglerX
Super Member
BRMyers
Platinum Member
As Dale stated, above, Ken's Bolt on Hooks. They are very easy to install because you are talking to someone that is mechanically challenged. My wife hates it when I try to start a project cause it always cost her more money than just having a professional come in and do it.
So, if I can install them, anyone can.
So, if I can install them, anyone can.
Diggin It
Super Star Member
I didn't want to drill holes and possibly weaken the structure. One or two holes seems like the hook could twist under stress and create a bigger mess. Grab hooks are cheap, a couple of bucks a piece. If you don't have a welder, there's a fair chance that a friend, neighbor or relative does who can do it for a small fee if any at all.
jmc
Elite Member
- Joined
- Jul 21, 2003
- Messages
- 3,099
- Location
- SW Indiana
- Tractor
- Ford 1920 4x4 (traded in on Kubota). Case 480F TLB w/4 in 1 bucket, 4x4. Gehl CTL60 tracked loader, Kubota L4330 GST
Actually, the manufacturer tested the bolt-on design under various conditions and posted them online. In test #5, the hook itself spread open but the bolts, attached to typical bucket sheet metal thickness, did not fail. 12,500 lbs failure load.
Ken's Bolt on Grab Hooks <<Proof Testing>>
OP
WranglerX
Super Member
If drlling a couple of 9/16 (clearance) holes weakens structure, it is to weak to be effective in beginning, whatever it is (FEL bucket) it needs to be replaced with better quality unit... Welding hooks to a questionable (structurally weak) unit has same effect on distortion of unit as bolt on items... And in my case I trust grade 8 bolts more than my welding...
Dale
kennyd
Advertiser
Everyone has an opinion...and I'm glad we live in a country that has the freedom of choice :thumbsup:
:united-states:
:united-states:
