Bucket Mounted Push Bar?

[DENALIAKITAS]

Is there anyone out there that makes a bucket mounted push bar? Something that would work for pushing around non running vehicles etc. Or has anyone made something up for themselves? Thanks

 

[avc8130]

Is there anyone out there that makes a bucket mounted push bar? Something that would work for pushing around non running vehicles etc. Or has anyone made something up for themselves? Thanks

I placed a tire between the loader and my pickup truck bumper to push it up onto the trailer once. Worked pretty sell.

ac

 

[pedalstomper78]

If you're doing this a lot Denaliakitas......does your loader have a QA on the front? You can buy plates for $130 or so on Ebay....put some tires on it and I think you've got a great way to push cars around.

In an automotive shop that I used to work at where we did a lot of "no start" diagnosis, we had a toyota 4-runner with a wood bumper with 3 tires attached to it. Pushed cars all over the place with that thing.

 

[DENALIAKITAS]

If you're doing this a lot Denaliakitas......does your loader have a QA on the front? You can buy plates for $130 or so on Ebay....put some tires on it and I think you've got a great way to push cars around.

In an automotive shop that I used to work at where we did a lot of "no start" diagnosis, we had a toyota 4-runner with a wood bumper with 3 tires attached to it. Pushed cars all over the place with that thing.

No my tractor doesnt have a QA setup on it. I am hoping to come up with something that can mount to the bucket pretty quickly like some of the bucket forks do. All i really need is a single vertical post or something thats padded so it doesnt scratrch up whatever i am pushing. Basically want to be able to push non running vehicles into the shop to work on them.

 

[bcp]

All i really need is a single vertical post or something

You could start with a clamp on receiver, then make a --| or L shape to plug in. Pad it and push.

Trailer Hitches for Tractors/Skid Steers | Clamp on Trailer Hitch | palletforks.com

Bruce

 

[DENALIAKITAS]

You could start with a clamp on receiver, then make a --| or L shape to plug in. Pad it and push.

Trailer Hitches for Tractors/Skid Steers | Clamp on Trailer Hitch | palletforks.com

Bruce

That would work, wonder where i could find a padded premade --| or L to go with it.

 

[texasjohn]

do you have a toothbar on the bucket...if so, I'd hang tires from the teeth, point the teeth up so the tires don't fall off and push away

 

[bcp]

You could have a local shop make something shaped like these. The hitch step may not be strong enough to push with.

30" Hitch Step with Pin

Without the ball mount:
8-in-1 Adjustable Ball Mount Hitch

A section of tire tied to it could be the padding.

Bruce

 

[Kioti Tom]

Tractor Supply has a hitch plate just about what you are looking for. SKU # 1891593 It is called a Pintle mounting plate. It is sold separately from the pintles and fits a 2 in. receiver.

Tom

 

[oldbones]

Don't know if this will work for you, but I built a wagon tongue type bar that I use to push/pull stuff around. I took a 10 foot piece of 2" pipe, welded two pieces of steel (with holes for hitch pins) on each end. It looks like a double ended wagon tongue. Hook one end to the tractor drawbar, the other end to the drawbar or receiver hitch of the disabled vehicle. With this, I can move whatever vehicle needs moved, using the tractor brakes to stop it. Just have someone steer the dead one.
No chain, no scratches, no runaways.