Building a Roll over box blade, But....

   / Building a Roll over box blade, But.... #1  

AKwelder

Silver Member
Joined
Sep 24, 2008
Messages
237
Location
Fairbanks Alaska
Tractor
Kubota B8200, 1953 International "Super C"
I have been looking at roll over box blades and want to build one. I just have a couple questions

- Is the pivot point on each side just a solid pin in a section of pipe? or does it have bearings?

- How thick are the side panels?


Thank you for your help
 
   / Building a Roll over box blade, But.... #2  
No bearings in mine and the side plates are 3/4" thick where the pivot is. CJ
 
   / Building a Roll over box blade, But.... #3  
No bearings in mine and the side plates are 3/4" thick where the pivot is. CJ
My Gill rollover is the same. Its very useful and heavy built all over. I found mine used [20+ years ago] and other than replacing the blade edges and a coat of paint , done nothing but work it! I am thinking of welding a receiver type hitch on it to handle trailers.
 
 

Tractor & Equipment Auctions

UNUSED CFG INDUSTRIAL H15R EXCAVATOR (A52706)
UNUSED CFG...
1999 Ford F-450 Mason Dump Truck (A53422)
1999 Ford F-450...
2022 MACK GRANITE TANDEM AXLE DUMP TRUCK (A54607)
2022 MACK GRANITE...
Miller Big 40 Portable DC Arc Welder Generator (A55973)
Miller Big 40...
New/Unused 20ft Bi-Parting Iron Gate (A54865)
New/Unused 20ft...
Gooseneck Livestock Stock Trailer - Tandem Axle Ranch Hauler - Selling Absolute, No Reserve (A55301)
Gooseneck...
 
Top