Building a Roll over box blade, But....

   / Building a Roll over box blade, But.... #1  

AKwelder

Silver Member
Joined
Sep 24, 2008
Messages
237
Location
Fairbanks Alaska
Tractor
Kubota B8200, 1953 International "Super C"
I have been looking at roll over box blades and want to build one. I just have a couple questions

- Is the pivot point on each side just a solid pin in a section of pipe? or does it have bearings?

- How thick are the side panels?


Thank you for your help
 
   / Building a Roll over box blade, But.... #2  
No bearings in mine and the side plates are 3/4" thick where the pivot is. CJ
 
   / Building a Roll over box blade, But.... #3  
No bearings in mine and the side plates are 3/4" thick where the pivot is. CJ
My Gill rollover is the same. Its very useful and heavy built all over. I found mine used [20+ years ago] and other than replacing the blade edges and a coat of paint , done nothing but work it! I am thinking of welding a receiver type hitch on it to handle trailers.
 
 

Tractor & Equipment Auctions

2014 JLG G12-55A 12,000lbs 4x4 Rough Terrain Telehandler (A53421)
2014 JLG G12-55A...
2016 Ford E-450 LP Handicapped Bus (A53422)
2016 Ford E-450 LP...
JOHN DEERE XUV590M (A53084)
JOHN DEERE XUV590M...
2009 Pontiac G6 Sedan (A55853)
2009 Pontiac G6...
2011 John Deere 5075 4WD Agricultural Tractor (A52377)
2011 John Deere...
2019 Chevrolet Silverado1500 LD Crew Cab Pickup Truck (A55852)
2019 Chevrolet...
 
Top