BX2200 Thermostat

[terpdog]

I'm getting no reading from the thermostat of the BX2200. I did just replace the Stop Solenoid. I don't see anything that I missed putting back(everything seems to work fine).

Didn't want to go get another thermostat if it's just a wire that I missed but I don't see anything and all the fuses seem fine.

 

[Roadworthy]

Replacing your thermostat won't give you a reading. The thermostat helps control the temperature of water circulating in the engine but it doesn't indicate anything. You probably mean you're not getting an indication from your temperature gauge. You could have knocked a wire loose from the sending unit while working under the hood. You can start by retracing your path to the stop solenoid and see if you pulled something loose.

 

[5030]

Replacing your thermostat won't give you a reading. The thermostat helps control the temperature of water circulating in the engine but it doesn't indicate anything. You probably mean you're not getting an indication from your temperature gauge. You could have knocked a wire loose from the sending unit while working under the hood. You can start by retracing your path to the stop solenoid and see if you pulled something loose.

+1.................

 

[terpdog]

Yes, I just had to be more patient tracing the wires. One wire that was near the front, by the stop solenoid was it. Of course I didn't find this until I pulled quite a few things off.... because.. of course I put those back on.