19th_VA
Gold Member
Haven't forgotten about posting a picture. In fact I did take one this past weekend. I'll post in the next day or so.
Century - Branson Controls
- Thread starter Pacesetter300
- Start date
- Views: 6247
19th_VA
Gold Member
O.K., here's a pics of my joystick situation. Have not tried Snowridge's fix yet. I do like to have the rpms up a bit with the throttle while doing loader work since it's one less thing I have to worry about while learning how to operate the loader. Oops, a little to fast with the continue button.
Attachments
19th_VA
Gold Member
OP
Pacesetter300
Silver Member
I can see where that might cause a problem, but is certainly doesn't look too terminal. When I sat on a 2028 with the C30 loader, I noticed I had to reach a bit. Had I bought that setup I would have modified the lever anyway. /forums/images/graemlins/wink.gif
Pacesetter
Pacesetter
19th_VA
Gold Member
It's definitely not the end of the world. Most of the time I don't even notice it. It is something Branson should correct, however.
