OP
SwedeSpeed
New member
2 high
CK20 Running hot
- Thread starter SwedeSpeed
- Start date
- Views: 15055
TJP89
Veteran Member
Yeah, too high is right:laughing:
(sorry, couldn't resist)
I'd try a low range gear. L3 or L4. See what that does.
OP
SwedeSpeed
New member
This tractor has 3 low range forward gears and 3 high range forward gears. 3 low is barely moving, if I mow in 3 low, by the time I'm done mowing I'll have to mow again.
Coyote machine
Super Member
- Joined
- May 4, 2009
- Messages
- 7,641
- Location
- Southern VT
- Tractor
- 22 SANY SY 50U, '10 Kioti DK 40se/hst KL-401 FEL, loaded tires, KB-2485 bhoe, Tuffline TB160 BB, Woods QA forks, MIE Hydraulic bhoe thumb & ripper tooth, Igland 4001 winch, & GR-20 Log Grapple. Woods BBX72" Brush Mower. Diamondplate aluminum canopy
What RPM were you 'normally' using? And what did you bump it up to recently on 'trial'?
OP
SwedeSpeed
New member
Was running about 2200, bumped it up to about 2700.
DK35vince
Super Member
The CK 25, 30 and 35 gear models are 8 speed shuttle.
I don't believe the CK 20 gear had shuttle.
OP
SwedeSpeed
New member
No shuttle.
I have a 2008 CK20S HST that i have been mowing with for 7 years now. I always run the engine at or a little above the little triangle and have never had a heat problem. I have mowed on days that it was 90 plus degrees out and still had no problem. The tractor has never overheated but can't say the same for the operator.
TJP89
Veteran Member
You are correct, there is no shuttle on the CK20, contrary to pictures on Kioti.com. Careful reading shows that the main shift is 3F gears and 1R gear, with a HI/LO range shift for 6F/2R, as the OP said. I was confusing the CK20 with the 2510 and 2410, along with the rest of the CK series.
Still, in 2H you're at the second fastest speed you can do, I'd drop it a gear to 1H, as the speed change has to be substantial with only 3. However, there may be another problem. Obviously check the screens and filters, as well as the coolant.
OP
SwedeSpeed
New member
Screens and radiator have been cleaned ( removed battery shop vac-ed out all debris, blew out radiator with med-pressure air from fan side) coolant looks clean, no oily residue, no bubbles and is topped up. Hood screens are free of debris and air filter has been replaced. Oil has been changed recently, topped up and no froth or any detectable abnormality. Could the pto be bound up somehow so that the tractor is working too hard to turn it?
