Compression Testing

[rock2610D]

Can anyone tell me if this will work?

I have a compression tester that goes to 300 psi. I have been able to screw the end of the compression tester into the fuel intake port of one of my old injectors.

If I remove the needle in the old injector will that work? Or should I remove the entire middle section of the lower injector? Better yet is there any way this could work. I realize I could have way more than 300 psi but if you think this will work all I will have to do is purchase a 5 or 600 psi gauge.

 

[HoyeTractor]

You can completely gut your injector and do it that way. We used to do it like that. Or you can buy one of our compression test adaptors for about $15 and not worry about damaging your injector if yours are still good. I think our kit has a gauge that goes to 1000psi.

Aaron
Parts@hoyeTractor.com
(940)592-0181