Hi All,
Can anyone help identifying this part from a MF 135, it has no thread but inserts into the end of the crank shaft and looks to hold the crank dynamo pulley on however it just falls out. It was held in by a large amount of grease and grime previously. Pictured also is the pulley that is on the MF 135.
There is a possibility that the "pin/plug" used to have a hex head on it that was stripped to the from axle pin coming loose and working its way towards it and wearing it round.
Any parts diagram would be useful as i have been struggling to fine anything.
Thanks
Can anyone help identifying this part from a MF 135, it has no thread but inserts into the end of the crank shaft and looks to hold the crank dynamo pulley on however it just falls out. It was held in by a large amount of grease and grime previously. Pictured also is the pulley that is on the MF 135.
There is a possibility that the "pin/plug" used to have a hex head on it that was stripped to the from axle pin coming loose and working its way towards it and wearing it round.
Any parts diagram would be useful as i have been struggling to fine anything.
Thanks
