After some maintenance being performed (rear wheel/hub reseal and new couplers), I now can’t get the front wheels into the 4x4 mode. Looking at the MX service manual, the selector arm is fairly simple looking and doesn’t appear to complicated to access.
The 4x4 mode did work after the above MX for a job I did, but wouldn’t budge the next day. The tractor is functional in 2x4 mode.
The arm feels like it is jammed in a position that it’s not supposed to be. Looks like Hyd fluid needs to be drained (again!), Roll pins removed and access plate removed to see what’s going on.
Any experience out there on this issue?
The 4x4 mode did work after the above MX for a job I did, but wouldn’t budge the next day. The tractor is functional in 2x4 mode.
The arm feels like it is jammed in a position that it’s not supposed to be. Looks like Hyd fluid needs to be drained (again!), Roll pins removed and access plate removed to see what’s going on.
Any experience out there on this issue?
